Perge valve - 2008 Chevrolet Colorado 2WD

hope it helps

look for ele. connection on or close 2 evap canister

No fault code says a certain part is defective, it simply put indicates a fault in that circuit, that can of course be a like the valve part or the wiring or the computer control module that sets the code. The valve is located near the gas tank under the car next to the carbon canister. It is your money guess if you want.

did u perge the air out

they have a tester called a smoke machine might be cheaper to just replace it rather than have it tested

Here's how to fix it: http://www.obd-codes.com/p0441

Check clamps on filler hose and vent hose make sure it's not leaking there.If fuel pump was changed before filler tube connection on tank maybe leeking when under vacumme from perge systme and setting code.

I would double check for any air leaks. Replace fuel filter. You will also need to reset computer after new parts are installed. This can be done with a hand-held scanner or diagnostic scanner

put more gas in it...if that didnt work u may have burnt out your fuel pump...disconnect the fuel line at the engine and turn the key on if gas come out ur pump works

i had the same problem, you have to change the perge control valve, its on the back of the engine below where the plastic intake pipe meets the metal intake manifold on the back side of the engine between the engine block and the firewall, on the underside of your car hood you will see a vacume system diagram, it will illistrate where the valve is, it should cost about 30 bucks or so at a hyundai dealership