Call Kia with your VIN to make sure yours wasn't affected by the recall. You may be able to have that rear bearing replaced for free at Kia.
HUBCAP & OUTER BEARING REPLACEMENT PROCEDURE: 1. Remove the two (2) cross-tip locating screws on the brake drum.
2. Remove the brake drum.
3. Remove cotter pin and cover set.
4. Remove nut, claw washer, outer bearing and hub assembly.
5. Inspect inner bearing area in both hubs for any sign of moisture, corrosion, grease discoloration or contamination. If "yes" discard entire hub and replace with new assembly. If "no" proceed with outer bearing replacement below: 6. Carefully remove the outer bearing race from the hub. If the hub assembly is damaged then replace the hub assembly as a complete unit. (If inner seal is damaged while removing the outer race replace with new seal.)
7. Clean all contaminated grease from outer bearing cavity of the hub.
8. Install a new outer race into the hub using an appropriate race installation tool.
9. Apply grease MS511-33 WBG2 or equivalent to the hub assembly and the new bearing(s) especially to the shaded areas.
10. Install hub assembly, new pre-greased outer bearing and new claw washer on spindle. (Or alternatively, install entire new hub assembly, as supplied). Ensure bearings are properly seated then tighten hub/spindle nut, torque nut to 20-25 lb-ft (27-33 Nm.) Verify hub spins freely without signs of binding or excessive play.
11. Install new cover set and cotter pin; never reuse the old cotter pin.
12. Install new hub cap with Loctite # 5910(TM) or equivalent sealant to prevent moisture intrusion.
13. Install the rear brake drum using tapered locating screws.
14. Install rear wheels and torque lug nuts to proper specification. (65-79 lb-ft) (88-108 Nm, 9-11 kgm)
15. Lower vehicle.
SOURCE: need to remove rear hub
The brakes are adjusted out. There is a slot on the back side of the hub on the bottom in the six o'clock position. You can get a brake tool or use a screwdriver. It is two pieces threaded with a wheel in the center of it. You must turn it so it brings the shoes inward. Yo'll know which way it's turning after a little bit. It can be a challenge but take your time, get comfortable <-that's key and turn away. The drum should slide right off.
SOURCE: replacing gear cables on a kia sedona
To change the gear change cables unpop the sliver center shroud un do about 10 self tapping screw. un do 4 13 mm bolts on gear stick bracket. this is all after you have taken gear knob off . which is held on by cable tie. then pop the bonnet remove air box. and disconnect cables red and black one on gear box linkage. and in side un do inspection plate brhind centre console .
431 views
Usually answered in minutes!
×