Question about 1995 Jeep Grand Cherokee

2 Answers

1995 JEEP GRAND CHEROKEE 4.0L NO START CONDITION-COIL HAS SPARK ,PLUGS GOOD,BATTERY GOOD,FUEL RAIL HAS FUEL

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Jeep Master
  • 1,075 Answers

Has this car been lying up for some time?,has any repair been done lately?,what im trying is to get away from the basic faults?let me tell you petrol has a sell by date,ie,,if the tank for a long time.it will not fire,please tell me more then I will pip point the problem....adrian

Posted on Dec 28, 2014

Ad

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 73 Answers

You said plugs are good but do they have spark

Posted on Dec 28, 2014

Ad

5 Suggested Answers

Anonymous

  • 1 Answer

SOURCE: 96 jeep grand cherokee wont start

my 1996 jeep is doing the same thing.the fuse I have been changing is under hood in fuse panel on left 20 amp sm. in center of fuse panel closest to bat.

Posted on Aug 22, 2008

Mikey108

Michael Zangari

  • 475 Answers

SOURCE: 2002 Jeep Grand Cherokee Lardo misfiring

You say you changed the cam sensor. A1391 code is a crank sensor on the top of the trans. bell housing.

Posted on Feb 24, 2009

Anonymous

  • 218 Answers

SOURCE: 1995 JEEP GRAND CHEROKEE RAN AND DIED WILL NOT START

IS IT THE 4.0L?IF SO U MAY HAVE A BAD CRANKSHAFT POSITION SENSOR.

Posted on Apr 28, 2009

66 chrgr

mike loshbough

  • 1011 Answers

SOURCE: 96 grand cherokee crank no start, no spark from

have the crank sensor replaced this controls the spark and injector pulse it is located on the drivers back side of the engine above the transmission housing!

Posted on Jun 11, 2009

Anonymous

  • 136 Answers

SOURCE: Changing spark plug wires on 2001 Jeep Grand cherokee

yah direct ignition coil pack does away for the need a a distributer cap and rotor.much higher energy ignition system where the computer tell when to fire.if that helps.not hard to change.as long as you change them one at a time so you don't screw up the order.

Posted on Nov 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1996 jeep grand Cherokee will turn over but not start. weak spark. fuel at fuel rail. replaced PCM 1 month ago. replaced crank shaft sensor 3 months ago....


See if your getting spark at the ign. coil first (passengers side on that year) if you are change the crank shaft sensor making sure you mount it as close to the engine as possible so it never gives you trouble again.

Aug 20, 2013 | 1996 Jeep Grand Cherokee

2 Answers

My 1995 grand cherokee takes a lot to start. turns over fine, but won't fire. checked fuel rail, no pressure. after trying 15 times or so, it will start and run just fine. starts right back up unl


Your Jeep has what's known as the delayed start, no check engine light problem. The Jeep will not start until the check engine light comes on, on the dashboard. Next time it cranks but will not start, look at the dashboard to see if the check engine light is illuminated. If it's not lit up, then your Jeep does have that problem and your Jeep ecu is in need of repair or replacement. There are components inside the ecu that are going bad and will continue to get worse, eventually leading to a permanent no start condition. There are ecu repair services and replacement ecus on ebay.

Jan 17, 2013 | 1995 Jeep Grand Cherokee

1 Answer

Where are the spark plugs


Locate the spark plug wires in the Cherokee cylinder head. In the 4.0 liter engine, the spark plugs are below the coil rail assembly. On the 4.7 liter engine, the spark plugs are located under each corresponding engine coil.


Read more: How to Replace Spark Plugs in a Jeep Grand Cherokee ' eHow.com http://www.ehow.com/how_4484626_replace-spark-plugs-jeep-grand.html#ixzz27zi6736d

Sep 30, 2012 | 2000 Jeep Grand Cherokee

1 Answer

I have a 1998 jeep grand cherokee with a 4.0 engine. As I was driving, the engine died. I have replaced the spark plugs, distributor cap and rotor, crank sensor, cam sensor and coil. It will turn over, but...


You really should be using a good manual as a guide fro testing. For wiring diagrams chiltons is better than haynes. Have you checked power flow through the ASD relay??

Jan 14, 2011 | 2000 Jeep Grand Cherokee

2 Answers

I have a jeep grand cherokee will turn over but wont run


I suspect the crankshaft position sensor, giving the info you provided.

Jun 13, 2010 | 1995 Jeep Grand Cherokee

1 Answer

Need guide to change spark plugs in 2004 4.0L grand cherokee


R&R COIL RAIL AND THE SPARK PLUGS ARE UNDER THE RAIL, BECAUSE EACH PLUG SHOULD HAVE ITS OWN COIL(COIL RAIL IS A ONE PIECE)

Nov 14, 2009 | 2004 Jeep Grand Cherokee

2 Answers

1993 JEEP GRAND CHEROKEE LAREDO IM TOTALLY BAFFLED


Back up a minute...Do you have spark from the coil wire? (juice from coil) If so, change or check rotor and cap (wires do not all go bad at same time so unless they are wet, likely at least good enough to start engine)

Mar 05, 2009 | 1993 Jeep Grand Cherokee

Not finding what you are looking for?
1995 Jeep Grand Cherokee Logo

152 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...