Best to start by removing the wheel, then the inner plastic fender...held on with plastic push up tabs...remove all under hood fender bolts...probably 13mm...compare your replacement fender to confirm all necessary bolts to be removed, Is your new fender already painted?
SOURCE: Front Left Sway Bar Link
The front stabilizer shaft (sometimes called a sway bar) is mounted to
the top rear of the frame and to the lower control arm. The shaft is
attached to the frame with clamps and rubber insulators and to the
control arms with insulator links.
Try http://www.autozone.com/shopping/repairGuide.htm
SOURCE: 2002 Pontiac Grand Prix Thermostat
as you face the engine the thermostat bell is on the right (drivers side) Follow the radiatoe hose. Remove the two bolts and raise the bell still attatched to the hose. the thermostat is there with the rubber seal. You can gently pry the thermostat out with a screwdriver or something similar. Put in new thermostat be sure it is the same as the old one, and then replace or change the seal (be sure it is the smae size and thickness as the old one as I got the wrong size from Napa) Then replace the bell, and tighten, but not over tighten. I hope this helps!
SOURCE: I am removing the right front fender on a 96 pontiac grand prix
U NEED TO TAKE YOUR FINDERWELL OUT FRIST ON THAT SIDE THIN OPEN HOOD THE BOLTS R RIGHT AT THE TOP WERE YOUR HOOD FITS THE FINDER SHOULD BEE ABOUT SIX OR SO NOTE THE FINDER WELL IS THE UNDER NEATH PART OF YOUR FENDER U MAY WONNA REMOVE YOUR PARKING LIGHT FOR THAT SIDE JUST TO MAKE SURE U DONT BRAKE IT AND JUST BELOW THE MARKER LIGHT SHOULD BEE A FENDER BRACE REMOVE IT ALSO ITS LIKE A SHORT METTEL BAR ALL BOLTS SHOULD BEE 1/2 INCH GOOD LUCK AND RATE THIS PLEASE
SOURCE: 02 pontiac grand prix front end roar started about
engine drive shaft bearing is bad...u have from motor. left and right side shafts. and each side has a inner by motor and a outer by wheel bearing so 2 bearings on each side.. replacing both...on either side.saves from having a second job done later
SOURCE: 2004 Pontiac Grand Prix GTP front pass turn signal doesn't work
you would need to buy a blinker relay
815 views
Usually answered in minutes!
Hi Raymond Porterfield, I want to help you with your question, but I need more information from you. Can you please add details in the comment box?
×