Is there a site that will explain how to reassemble a power seat switch on a 1998 land rover discovery. Lots of parts and bearings.Thx Marty

Hi welcome main problems are the abs valves causing the 3 dash lights (search 3 amigos online) a really badly sited compressor can cause air suspension models to fail giving the bags a slow leak the V8 is a solid engine but can have radiator expansion tank and cap failures
the other issue is electrics windows and door looms are problematic

1. Pull out side facing seat or pocket cover.
2. Unscrew fastener and remove access panel.
3. Turn bulb holder anti-clockwise to release.
4. Remove bulb.
Refitting is reverse of the above procedure

http://landroverforums.com/forum/discovery-ii-18/inhibitor-switch-install-47239/ Here's a link to forum about your inhibitor switch.

It uses hydraulic power steering fluid NOT aft! - download this (Free Rave manuals - Rover Bible) - http://www.landroverresource.com/

Check fuses under your seat there's 3 of them. Visually pull and inspect them.

The serpentine belt routing diagram for a 1998 Land Rover Discovery 4.0 liters with A/C


CS = Crankshaft
F = Fan pulley
G = Guide pulley
Gen = Alternator
HP = Hydraulic Pump
T = Tensioner
AC = Air Conditioning
PAS = Power Assisted Steering

oil pressure dangerously low so overheating and bearing failure inimimently soon

YOU NEED TO CHECK THE FUSE

Check wiring downside the back seats And also check the ground wire

Hi marty, it sounds as if it could be the coil or the resistor under the coil just feel the coil and see if it is very hot if it is that could be the problem hope this helps