Head light are not coming - which fuse I need to change. Please confirm the number of fuse. please reply me.

High beam and low beam are different circuits in the lamp socket. Try probing with a volt meter or test light at the head lamp socket, or try with new head lamps.

What about the turn signals what happens when you use them? Please reply. Also I would check both the fuse boxes for the blown fuses, check them all. As far as I know there is not inline fuse for the a/c

If you need further help, I’m available over the phone at https://www.6ya.com/expert/edward_020b3320326d263d

not a fuse problem bad switch

YOUR IN NEED OF ENGINE MAINTENANCE

Welcome to fixya

Hello

I have a solution for this

Press Ok, Accept or replay so we may get started

Your pre-solution is coming up shortly

PLEASE REPLY OR LEAVE COMMENT TO CONFIRM YOU RECEIVED THIS EMAIL

My name is Bruce

Welcome to fixya

Hello

I have a solution for this

Press Ok, Accept or replay so we may get started

Your pre-solution is coming up shortly

PLEASE REPLY OR LEAVE COMMENT TO CONFIRM YOU RECEIVED THIS EMAIL

My name is Bruce

Welcome to fixya

Hello

I have a solution for this

Press Ok, Accept or replay so we may get started

Your pre-solution is coming up shortly

PLEASE REPLY OR LEAVE COMMENT TO CONFIRM YOU RECEIVED THIS EMAIL

My name is Bruce

Welcome to fixya

Hello

I have a solution for this

Press Ok, Accept or replay so we may get started

Your pre-solution is coming up shortly

PLEASE REPLY OR LEAVE COMMENT TO CONFIRM YOU RECEIVED THIS EMAIL

My name is Bruce

My guess is you mean misfires, not backfires. How does vehicle run when warmed up? I'm also thinking that the misfire codes are coming from a lean mixture situation. No other codes coming up either? Please reply with year, make, model, and engine, just to confirm heading etc., please.

You know the fuse for the high beams is good ( Cab fuse panel fuse # 16 ) and the pass low beam fuse ( cab fuse panel # 26 ).
Might want to check cab fuse panel fuse #28 ( this is the driver's side low beam ).

If this fuse has power on both sides ( with the low beams on ) next you can pull the headlamps, and check for power at the connectors, but depending when the last bulb change took place, I would say you need need bulbs. ( need at least 1 for the high beam out )
Confirming with a meter at the headlamp would be a good idea, before spending the money.

The bulb connector has 3 pins.
Black wire is ground on both sides
Light Green w/ Black stripe wire is high beams on both sides
Driver Lo = Dark Blue w/ white stripe
Pass Lo = Dark Green w/ Orange stripe.

try checking your fuse