How do I adjust the new throttle position sensor on a 2005 Kia Sedona LX

SOURCE: where is the crank position sensor located in 2005

Hello martinezmelm: My name is Roger and I can answer your question. To locate the crankshaft position sensor. You will need to remove the timing cover. You will find the sensor on top of the crankshaft gear. Between the V of the timing belt.
Should you need further help please just ask. Please rate the answer as this way I know it was helpful. Thank You for using Fix Ya. Roger

SOURCE: Where is the input speed sensor on KIA sedona 2005

on transmission has 2 wires at right side of trans .by axel

SOURCE: How to change the oil on a 2005 Kia Sedona

The oil filter is towards the front of the car, underneath on the passenger side, at the corner of the engine cradle. Loosen the drain plug and drain the oil. Make sure the old oil filter gasket came off with the oil filter. Reinstall the new oil filter. Reinstall the drain plug and fill with 5 quarts of 10w/30 motor oil.

SOURCE: Crankshaft position sensor replacement on 2005 Kia Sedona

The CPS is located under the timming cover 4 small bolts remove the cover and the sensor is viewable 2 bolts have to be loosend and the wire leads up to a dual connector on the left side of the engine

SOURCE: where is the crankshaft position/crank

Hi, at the front of the crankshaft. if its near time for the timing belt, you want to replace it along with any pullies, tensioner and water pump


The crankshaft position sensor is mounted on the engine near the crankshaft.

Operation

The crankshaft position sensor is a Hall-Effect sensor that senses the crank angle (piston position) of each cylinder and converts it into a pulse signal. The signal from the sensor is relayed to the ECM to indicate engine rpm and the position of the crankshaft.

Removal & Installation

1. Disconnect the negative battery cable.
2. Disconnect the connector from the sensor.
3. Remove the bolt that retains the sensor in place.
4. Remove the sensor from its mounting. To install:
   
   1. Installation is the reverse of the removal procedure.
   2. Clearance between the sensor and the sensor wheel should be 0.020-0.059 inch. 2002-2005
      
      1. Properly connect the scan tool.
      2. Start the engine and allow it to idle.
      3. Be sure the idle position switch is ON.
      4. Specifications are as follows:
         
         Temperature - 4°F, test specification 1500-1700 RPM Temperature 32°F, test specification 1350-1550 RPM Temperature 68°F, test specification 1200-1400 RPMTemperature 104°F, test specification 1000-1200 RPM Temperature 176°F, test specification 650-850 RPM