1. Check for battery voltage to the Mass Air Flow Sensor on the Red/Green wire.
2. Check for 5.0 volt reference to the Mass Air Flow Sensor on the Red wire.
3. Check the Mass Air Flow Sensor ground on the Black wire - look for 0.05 volts or less.
4. Check the Mass Air Flow Sensor output voltage on the White wire - look for about 1.35 - 1.41 volts at idle.
Have to look up the specs
In general you need about 16 oz (Volume) in 15 to 20 seconds
SOURCE: 2007 nissan altima fuel filler release button
Try having someone push in/out slightly on it while you trip it.
SOURCE: where is my fuel filter 2001 nissan altima
Most of the time there is an inlet screen/filter in fuel tank attached to fuel pump. But there should be another filter between tank and fuel rail. it should be located on the firewall, so if you work backward from an injector toward the gas tank you will bump right in to the filter along the way.
SOURCE: How do I change the passenger side headlight bulb on 2001 Altima
Open up the hood, and go in behind the fixture where the light is located. Sometimes there is an access panel on top. Open it and reach down inside and grab the bulb’s socket. Twist the socket a quarter turn counter clockwise, and pull out the socket. Grab the bulb, and pull it straight out. To replace the new bulb, never touch it with your bare fingers, as this will greatly shorten the bulb's life, if it even work's at all. Use a tissue or something else in that order to handle the new bulb. Push the new bulb into the socket, put the socket back into the housing, and twist a quarter turn clockwise to secure the socket into the fix.Seems that you have to remove the coolant bottle(two screws), and also the unscrew the washer fluid bottle, after that you can reach the socket that holds the bulb. There is a wire that holds the bulb in. if you loosen the screw you can tip up the wire and be careful to leave it in place...also the long side of the wire seems to connect to ground wire for the light...
SOURCE: 2001 Nissan Altima GXE turn signals comes on then goes off.
possibly the wires are loose or shot mayb try and replacing them
244 views
Usually answered in minutes!
×