In my land cruiser Jeep the diff lock button is working properly but in switch board all the time the diff lock indication light is on what can I do for it ?
SOURCE: 1997 Toyota Land Cruiser rain water leak
check the sunroof drains,they may be clogged they are located on the right and left front of the sunroof.
SOURCE: 2000 toyota land cruiser door power lock
This is normal if I'm reading this right. The door locks are supposed to pop up when you turn off the key when in "child proof" mode. The reading lamp is wired to prevent low battery conditions by only operating when the engine is running. Did you just get the car?
SOURCE: differetial locks for 94 land cruiser
91-97 Land Cruisers had a factory option for front and rear locking differentials. This is a seperate switch and is usually located to the left of US model Land Cruisers. The center dash button locks your transfer case differential changing your Land Cruiser from all wheel drive to four wheel drive depending if you have ABS or not this button either says ECT or Center Dif Lock. If you do not have the Front/Rear locking differential option then your Land Cruiser has open Front and Rear. Hope this answers your question.
SOURCE: my 00 toyota land cruiser
Yes!! probably the front diff actuator is sticking , the wire that command the disengagement is not making contact properly, or the actuator itself is bad, also if you replace the tires with a size different from the manufactures that can create an engagement problem.
Flavio P
Master Diagnostic Technician for Toyota
If you need further help, I’m available over the phone at https://www.6ya.com/expert/flavio_517b938f50183b92
SOURCE: swapping out radio from salvaged
Is the salvaged radio EXACTLY the same as the original radio? Are you sure everything is plugged in correctly? If the radio is not EXACTLY the same. the circuits could be different and the wiring harnesses may not provide power at the correct pins on the radio. Also, do you have the security code for the salvaged vehicle? The code for your radio will not work in the salvaged vehicle radio.
Also check to be sure that you did not cause the fuses to blow when disconnecting/connecting radio components. If you attempted this job without first disconnecting the battery cable, there is a very good likelyhood that this has occured. Damage to the salvaged radio could also have occured if the salvage vehicle battery was not disconnected during removal of the salvaged radio.
102 views
Usually answered in minutes!
×