Need torque settings for mazada 3 1,6 z6 engine

gasket torques

This site has a lot of torque specs. http://www.championbrands.com/aera-torquespecs.pdf

very easy just go to reliable-store it has all manuals
there many other websites also but in this matter this website is too good

This link should be of help for you.

http://www.championbrands.com/aera-torquespecs.pdf

1 its very new ,try to buy a repair manual, your asking for a lot of data

Borrow a repair manual for it from the libarry,

i am replacing the heads on a GMC 350 cu in engine. what is the final torque of the head bolts?

WHITE smoke is the sign of water being burnt in the engine and coolant coming out the exhaust is not good So get it checked out at a MAZADA Dealer work shop before anything bad happens to the engine

Head Bolt Torque For your 1994 Oldsmobile Cutlass Supreme (3.4L SFI DOHC): Foot pounds (Final torque) Note: Torque sequence --------- | 6 2 3 7 | | 5 1 4 8 | --------- Step 1: torque in sequence to 33 Ft/Lbs Step 2: turn an additional 90 degrees Recheck final torque in sequence *** CAUTION ***engine uses Torque To Yield head bolts (TTY) thatpermanently stretch during the initial installation.New head bolts must be used when cylinder head isreplaced or re-installed to obtain proper torque. Foot pounds (Final torque) Note: Torque sequence --------- | 8 4 1 5 | | 7 3 2 6 | front --------- of engine | 6 2 3 7 | | 5 1 4 8 | Step 1: torque to 40 Ft/Lbs --------- Step 2: turn an additional 90 degrees Recheck final torque in sequence *** CAUTION ***engine uses Torque To Yield head bolts (TTY) thatpermanently stretch during the initial installation.New head bolts must be used when cylinder head isreplaced or re-installed to obtain proper torque.

start off in order
remove earth from battery
remove
starter motor
drive shafts
clutch slave
bellhousing bolts
if auto remove torque converter bolts
wiggle out gearbox