SOURCE: Prob's with my Audi A6 2003 Auto 3.0 V6 (gearbox)
Doubt it as the fault suggests you need to look into the range sensor. If similar to Renault there is a switch on the gearbox that senses where the select lever is (at the gearbox end). If the display is wrong then the sensor needs looking at and either it will need to be adjusted into a set position by moving it, or perhaps the connector to it or wiring to/from it have a fault.
SOURCE: I have a 98 Concorde
You need to check the linkage. Under the car, the section that connects the gear shift stick to the transmission rods.
SOURCE: '89 dodge dakota manual transmission A535 will not
Most likely solution is the gear selector fork in the transmission has broken and is no longer engaging the gears.
Repair requires transmission removal and partial overhaul.
Testimonial: "good diagnosis. right on the money"
SOURCE: shift stick on saturn wont shift into gear moves
IT SOUNDS LIKE THE LINKAGE IS EITHER UNHOOKED, OR BROKEN! CHECK THERE FIRST!
SOURCE: I just changed my honda
You may need to find out if the transmission has a leak or is a cvt type of transmission.If the vehicle has a cvt transmission and the incorrect fluid type was used can cause major problems.You should contact the facility that performed your service. If the shop that performed your service used the wrong fluid type the liability falls to them for repairs unless you changed fluid because there was an issue already. If it was just maintenance to have serviced the tranny and this is end result definitely contact the repair facility.
36 views
Usually answered in minutes!
×