I was having trouble with the ignition and @ that point the remote started stopped working. It still locks and unlocks the doors. Replaced the ignition sensor so truck now starts properly but the remote starter still doesn't. I tried to reset it to make sure it wasn't on the valet parking mode but that didn't resolve the problem. BRR it's getting cold out there and I miss my remote starter please help!!
SOURCE: remote starter does not work but will unlock and lock doors.
depending on your alarm which it sounds like a viper model maybe? on my 02 you have to incorporate a factory alarm bypass module in order to be able to start the truck, they run about 100.00 bucks and have to be profssionally installed. The truck wont start because the computer isnt recieving the proper starting sequence due to the factory alarm
SOURCE: remote starter does not work but will unlock and lock doors.
this function is preformed through the Body control module, this can be tested for faults by the dealer only.
SOURCE: remote starter does not work but will unlock and lock doors.
I have a 2003 sierra and my remote starter would not work, it would lock and unlock only, checked out this site found the solution, tried it and in two seconds i solved the problem, Just press the lock button and the start button and viola it works again, thanks for all your help , GGGreat site glad i found it John
SOURCE: 1994 Lexus LS 400 Valet Lock Stuck - Can't Open Trunk
you have to have a main key. you may be able to remove the panel and release that way. under dash. pull cable.
SOURCE: 1996 chevy tahoe 4wd LT 4Door 5.7L Vortec. Truck
i suggest removing the flywheel inspection cover, and rolling the engine over a little bit at a time, checking to make sure that there are no worn or broken teeth. also, make sure there is no lateral movement, which could indicate a broken flexplate. good luck.
440 views
Usually answered in minutes!
×