Question about 2007 Chrysler Sebring Sedan
I damaged the front end of the vehicle in a fender bender which broke the plastic on the front of the headlight. Headlight worked for a while then bulb broke (low beam only). Replaced and that worked for a while until that one broke as well. Tried to replace that bulb and headlight (low beams driver side) still will not work. Changed the fuse and then bought brand new headlight assembly, installed and still low beam will not work. What else could be wrong? The high beams and yellow light on the other side still work.
The socket is bad. Replace the headlight low beams drivers side not that hard. Can buy them in autozone
Posted on Apr 09, 2015
Check the relays and it's fuse.
Since this was damaged, check the wires for broken hot wire or for bad grounds.
Hope this helps.
Posted on Apr 09, 2015
Try the fuses or wire fuse links , the only other thing in the circuit is the wires broken or the light low switch is bad
Posted on Nov 09, 2014
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Ill guarantee you have an electrical short on the left side of the headlight switch,circuit.From here its immpossible for me to go any further.Good Luck.,Get A Wiring diagram.
Posted on Apr 18, 2009
SOUND LIKE DIMMER SWITCH BAD.
Posted on Jun 13, 2010
Testimonial: "thanks for your help. turns out it was just bad bulbs. should have known better than buy cheap bulbs off the net.ruined my old set by taking them in and out of the harness. luckily new bulbs solved the problem.the advice was greatly appreciated though."
Hi, if you have a meter to check the bulb, use it to check the wiring to the socket or wiring for power when light switch is turned on. You should have around 12 volts depending on year and type of truck or auto. If the old bulb was burned, you should have power there. When you turn on switch, the other side should work and you will know you have power and it may just be corroded. Check this and you should find the problem. Please keep me posted on this, I will be around to help you. Please rate me kindly if I have been of help to you.
Posted on Jul 06, 2010
SOURCE: Hello, The low beam on
it is most likely a blown fuse as the HIGH & LOW beam lights may have separate fuses, check the fuses in the fuse box under the hood or under the dash...... hope this helps......cheers.
Posted on Sep 22, 2011
Tips for a great answer:
Apr 29, 2016 | Cars & Trucks
on Mar 17, 2010 | Dodge Durango Cars & Trucks
Apr 11, 2014 | Oldsmobile Cars & Trucks
Mar 22, 2011 | Chevrolet Cavalier Cars & Trucks
Feb 09, 2011 | 2006 Pontiac G6
Oct 02, 2010 | 2002 Jeep Grand Cherokee
Nov 12, 2017 | 2008 GMC Acadia
Oct 24, 2009 | 2002 Chevrolet TrailBlazer
Aug 23, 2009 | 1989 Cadillac Seville
Apr 10, 2018 | 2007 Chrysler Sebring Sedan
642 people viewed this question
Usually answered in minutes!