SOURCE: oil change procedure on a 2005 Hyundai elantra
it is very easy to change the oil put the car on ramps secure the back end look for the drain plug underneath the engine make sure you have the right size wrench and when you remove the plug also check the gasket on the plug to make sure it is not cracked you will also need an oil filter wrench and my other suggestion to you is to go to autozone to see if they have a Haynes repair manual for your car and if they don't see if they can order you one in the mean time they can also print you off a diagram of how to change the oil in you car safely
SOURCE: Remove door trim to replace power window switch
you dont have to take the trrim off on this car look at the outline of the switch open from rear and pull forward then you can change the window switch/ Please rate my response thank you very much
SOURCE: need power window diagram for 2000 hyundai elantra
is this what your looking for??
Front Door Glass:
SOURCE: my drivers side seat belt is not retracting on my 2005 hyundai el
Most of the time this happens because the belt gets twisted behind the B pillar trim panel. The lower portion of the panel that the belt goes behind can be removed enough to see behind it by gently pulling outward, it is held in place with plastic clips. If the belt is twisted up in there, untwist it and snap the panel back in place.
Testimonial: "that was it. thanx!"
SOURCE: need fil for error code P2626 Hyundai Elantra GLS
P2626 O2 Sensor Pumping Current Trim Circuit/Open (Bank 1 Sensor 1)
I'll sure this has to do with a faulty O2 sensor. This sensor is usually
located around the header of your car, or down more on your exhaust.
Try disconnecting your battery for 30 mins, hook it back up, and start
your car again. This will erase the error. See if it comes in again.
Hope this help (remember rated this post).
776 views
Usually answered in minutes!
×