Question about BMW 318

1 Answer

My bmw 318i 2001 model e46 engine.while driving at high speed just stalled.have no acceleration.its cranking,firing and it looks like too much fuel also ******* to the plugs

Posted by Anonymous on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 37 Answers

Get the air flow meter checked.

Posted on Jan 20, 2015

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Scott

  • 420 Answers

SOURCE: 2001 FORD F150 ENGINE SURGES AND DIES AT IDLE

Check all of your vacume lines. If it isn't a vacume line it is most likely the O2 sensor.

Posted on Apr 16, 2009

Anonymous

  • 3 Answers

SOURCE: bmw 318i e46 idle bad

try disconnecting the air mass meter sensor if it runs better then ur air mass meter has failed had the same problem

Posted on May 15, 2009

Anonymous

  • 36 Answers

SOURCE: engine speed will not rev over 4000rpm

Sounds like a fuel filter issue. If the filter is clogged or is getting to the point where it's going to be clogged badly the amount of fuel going to the engine will be restricted. This would cause your stated problem. Theoretically there isn't much of a need to go over 4000 rpm unless you are racing with the car but I think most bimmer owners can understand where you are coming from:) As far as the 1993, I'd check all your intake piping and vacuum lines and make sure there are no leaks whatsoever. An easy way to check is to have the car running and spray carb cleaner on the intake piping and such and see if your revs increase, if they do you've got a leak. Hope this helps! I'd be glad to help with any other questions you might have a please don't forget to rate me.

Posted on May 23, 2009

Anonymous

  • 11 Answers

SOURCE: Would a crankshaft sensor fault cause my BMW to just cut out?

Short answer is yes it would. Not the only thing it could be but to answer your question, yes.

Posted on May 28, 2009

Anonymous

  • 239 Answers

SOURCE: e46 2000 318i hunting on idle

Clean or replace idle control valve.

Posted on Sep 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Bmw 318I e46 plugs firing


That is what plugs do. Fire the fuel in the cylinder under compression.

Sep 07, 2017 | BMW Cars & Trucks

1 Answer

Whilst driving my e46, M43 engine, 318i, 2001 year model, my car picked up a miss and it stopped idling. It also had no power as the engine sounded roudy when i reved the engine. What happened?


Did you replace the spark plugs with the same brand recommended by ? Might also what to go over all the wiring harnesses, you disconnected when replacing the exhaust. Might of pinched a wire.

Sep 03, 2016 | 2001 BMW 318i

1 Answer

BMW E46 318i Fuel consumption problem it is apparently using 1 mile of fuel every 100 meters. BMW E46 318i


Could be many things, but fuel pressure regulator, leaking injectors are most likely. DO NOT DRIVE UNTIL FIXED. If the fuel is really getting into the oil pan, oil will be diluted and could damage engine bearings.

Jul 01, 2015 | Cars & Trucks

2 Answers

I have a Semi-Automatic 2005 BMW e46 318i. The engine randomly cuts out (stalls) when decellerating, coming to a stop, or when stopped. Other than this problem the car drives fine, and the engine starts up...


The problem you are having sounds suspiciously like the torque converter is not disengaging to allow your engine to spin freely until you are ready to accelerate.If when decelerating or coming to a stop you feel a jerking sensation similar to driving a vehicle with a manual transmission and bringing the vehicle to a stop without depressing the clutch, then the problem you are having is faulty Torque Converter Control Solenoid or a bad Torque Converter itself. If you have any other questions please contact me here. Good luck.

Mar 18, 2011 | 2005 BMW 3 Series

1 Answer

Bmw 318i 2001 model just stopped while driving


you have problem with tank mybe is dirty and you must check fuel filter and fuel pump

Nov 22, 2009 | 1999 BMW 318 ti

1 Answer

Stalls upon acceleration and back fires during engine speed.


check your fuel presher . mazda have a high fuel presher,

Apr 20, 2009 | Mazda B2200 Cars & Trucks

6 Answers

Bmw 318i e46 idle bad


try disconnecting the air mass meter sensor if it runs better then ur air mass meter has failed had the same problem

May 30, 2008 | 1999 BMW 318 ti

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

158 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

70 Answers

Doberman

Level 2 Expert

261 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...