SOURCE: how do i change the front brake pads
First make sure you have the park brake on
Raise the front end make sure to support with jack stands
Remove tires
this should leave the front brakes exposed
there are two slide bolts holding the caliper in place loosen both and remove
then wedge a screw driver between the inner pad and the rotor and lightly pry towards you to take some pressure off of the caliper
you should now be able to lift off the caliper it will still have the brake line attached to it so be sure to secure it to something ie a bungie strap to the suspension or something do not just let it hang by the brake line
slide out the old pads out of the caliper mounting braket
now take a caliper press and push the piston back into the brake caliper use the old inner pad do not push directly on the caliper piston (if you dont have a caliper press just substitute a c clamp it works fine)
if replacing the rotors remove the caliper bracket once again two bolts
remove the caliper bracket
remove rotor
Make Sure to inspect the caliper for leaks or damage
To install reverse and youll be done before you know it
Make sure to lube slide pins with a small amount of brake grease and make sure the caliper moves freely apon installation
After you have done both sides
set down car and slowly pump the brake pedal about 15 times to close the distance between caliper piston and brake pads thats all
I hope this helps
SOURCE: timing belt on my 2002 hyundai accent 1.6 liter 4cyl
DID THE BELT BREAK AND THEN IT WAS CHANGED. If so then you may have bent valve. IF NOT then vehicle may be timed wrong. Here is a diagram of your timing marks, http://www.2carpros.com/car_repair_information/tec_info/2002/hyundai/accent/2002_hyundai_accent_timing_belt_diagram_marks.htm contact if you need more help. Thanks for using FIX YA
SOURCE: how do you remove radio from hyundai accent 1998
You have to take out the ash tray, and remove those two screws, then pop out the center dash trim. Careful, though, you have to take out a lot of the wiring inside of your center dash trim in order to pull it out for enough room to move the radio in and out. I'm doing this right now, actually..
SOURCE: changing timing belt on 2004 hyundai accent
Sign up for an account on hmaservice.com. Once you do so, log in and click on "Shop". You can then enter your year/make/model and you will find the info under, engine mech. system>timing system>timing belt>repair procedures. Very detailed, and best of all, FREE.
SOURCE: When should I change my timing belt on my 2007
you wont need to change it until at least 100,000 miles. Typically that will last the life of the car. But alot of people, including myself, wait until it breaks to replace it. It is about $1000 to replace because the engine has to be partially disassembled.
53 views
Usually answered in minutes!
×