Remove the wheel, remove the brake caliper, remove the caliper bracket and rotor. Remove the nut from the axle. Remove the two bolts and nuts from the strut. Pull the spindle out and push the axle in. You might have to use a hammer and punch to get the axle to go in. Don't hit the axle with the hammer, you could mess up the threads. You only need the axle back far enough to get a socket on the bearing bolts. Then remove the three bolts that hold the bearing. unplug the sensor. You might have to beat the bearing out. If you have access to air tools/impact guns, get them. Makes the job much easier. If not, have breaker bars and cheater bars handy.
SOURCE: 2006 Saturn Vue Wheel Bearing
it should come out once you have disconnected:Brakes,strut,ball joint.tire rod end,cv joint!if it is not put the cv joint nut back on until safe enough to give it a tap with hammer to knock back & out shaft this should come as one piece HUB the bearing is pressed in! better to change whole HUB good luck this hopefully helped you out!
SOURCE: how to replace wheel bearing hub
its not the same. the gm is a bolt on hub and bearing. on the mazda, its a press in. you need to remove the steering knuckle and use a hydraulic press to press the old one out and the new one in.
SOURCE: How is front wheel bearing replaced on a 2001 Volvo S40?
most front wheel bearings are pressed in you half to take the whole control arm off pull out the hub press out the bearing grease the new one and press it in its best to take it to a machine shop do not try pressing it in yourself
SOURCE: Remove the wheel bearing/hub assembly from the
need detailed pictures of how to change rear wheel bearings on a chevy equinox
361 views
Usually answered in minutes!
×