On the passengers side possibly under a trim piece on the center console by the fl
SOURCE: REPLACING FRONT HUB STUDS FOR A 98 HONDA PRELUDE
To remove that hub you will destroy the bearing. Because you have to remove it with a slide hammer. It is not necessary to remove the hub to change the studs. Remove the caliper, caliper bridge and rotor. Using a hammer simply knock out the stud or studs you want to replace. Put new stud in and using a sleeve that has a bigger diameter than the stud (I use a big nut, like the one on the axle) put big nut over stud and screw lug nut on stud and tighten until head of stud is flush with hub. Re-install rotor, caliper bridge and caliper. Hope this helps.
49 views
Usually answered in minutes!
×