I have a toyota highlander 2002 it make a loud annoying sound for about 10 seconds when you put the key in the ignition and after you turn it off. What is it
Visit the on-line store, know as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem.
TOYOTA HIGHLANDER 2001 2002 2003 2004 2005 2006 2007 SERVICE REPAIR MANUAL
SOURCE: ignition switch on a 2002 chevy trailblazer
under the steering column, there are three or four little holes in the plastic covering. If you look inside, one of them (the one on the right side toward the dash) there is a brass pin inside. This is the pin to release the key. As far as the key not turning, I have had the same problem. The first time I replaced the ignition switch and that solved the problem. However, this makes no sense because the ignition switch has nothing to do with the tumbler being locked. GMC thinks that my anti theft system, which is inside the ignition cylinder is the problem. By removing the ignition switch, it reset the pass lock anti-theft system and temporarily fixed the problem. So, try removing the ignition switch and then plugging it back in. If that doesn't work, your in the same boat as I am, and we may both need new ignition cylinders.
SOURCE: 2008 Toyota Highlander, low pressure light turned
Welcome to FixYa.
Note that the SPARE tire is also monitored. Reset the spare tire pressure, and then press the reset buttoen. You should be ok then.
SOURCE: 2003 Toyota Highlander clock resets when I turn off the ignition
Have you checked any fuses? Does the climate control light up? If not then in the under hood fuse box (left of drivers side) check the ECU-B fuse should be 7.5 amp. Check the heater fuse in the fuse box inside the car it should be 15 amp. If the fuses are OK and only the clock is bad check out my site www.autoclockrepair.com I offer a repair service.
SOURCE: 2002 Toyota highlander passenger brake light not working
RE: 2002 Toyota Highlander 2.4cyl. 4X4 Base Model
I am a Certified Technician and have basic knowledge with electronics in electrical wiring. I searched the web and discovered this is a common problem.
I fixed the problem and it was a simple procedure... The problem is with the reverse light socket at the side with no brake light. This socket functions as a hub to direct current to the brake bulbs.
Remove reverse light socket and re-seat bulb. Check for loose or broken prongs. Replace if necessary.
Swap the reverse socket with the other side.
No need to panic rush through this procedure, just do it right. Haste makes waste.
1. Simultaneously depress and release brake and accelerator pedals 1 time.
2. Insert an original Master Key into the ignition but do not turn it.
3. Within 15 seconds depress and release accelerator pedal 5 times.
4. Within 20 seconds depress and release the brake pedal 6 times and remove key.
5. Within 10 seconds insert New Key into ignition but do not turn it.
6. Within 10 seconds depress and release the accelerator pedal 1 time.
7. Now sit and wait for about one minute until the security light in the center counsel stops blinking and turns off.
8. Remove new key and depress and release brake pedal 1 time.
9. Test your key now. It should work if you followed the instructions. If not, you may want to try the following instructions:
This procedure is for 2002 Camry and most other models in this year of Toyota. In the future always give the model as well as year and make. Thanks
126 views
Usually answered in minutes!
Hi Anonymous, I want to help you with your question, but I need more information from you. Can you please add details in the comment box?
×