Need to know how the wires goes n a new starter

under hood fuse box--k301. Your owners manual should have this.

Yes there is a starter relay in the wiring diagram.
The yellow and lite blue wire goes from the starter solenoid to the relay. There is a yellow wire from the relay to a 30amp fuse. The key switch powers thru the neutral safety switch and then powers the relay on.

turn on head lights have some one try and start car if the lights do not go dim then the starter is not drawing any power take starter out replace or rebuild can take starer out and hook to the battery its a 98 should have put 3 or 4 starter in by now I have

the positive (+) battery lead goes from the battery to the solenoid.....cheers

Please see my tip at http://www.fixya.com/cars/r5973094-starter_replace . These are generic instructions. Specific instructions for your car from autozone.com are pasted below. Please get back to me if you have any questions.

Removal & Installation

1. Remove or disconnect the following:
   
   Negative battery cable and properly isolate to prevent accidental reconnection Red solenoid safety cap Wires from solenoid 2 upper bolts 1 lower bolt and starter

Fig. Starter motor mounting


To install:

1. Install or connect the following:
   
   Starter and lower mounting bolt 2 upper mounting bolts. Tighten all 3 bolts to 15-20 ft. lbs. (20-27 Nm). Wires from solenoid and tighten the nut to 40-50 inch lbs. Red solenoid safety cap Negative battery cable

Unhook the battery and change one wire at a time

you need to find the starter solenoid and jump the two largest posrs with booster cables .if it canks repace the starter.if all your hearing now is a clicking sound you need to jump power to the solenoids start wire,a push on wire on the smaller post of the solenoid ,if it cranks replace the solenoid.if neither makes it crank,repair the grounrd cable or remove the starter and remove the rust from the nose cone and the mounting point.

The positive battery cable goes from the battery to one side of solenoid.(big nut). The cable that goes to the starter connects to the other side of solenoid.(big nut). Sticking out the front of the solenoid there is 1 or 2 smaller terminals. There should be a single wire (approx. 14ga or 16ga) that breaks out of the harness near the solenoid that has a black "L" shaped "push" on connector on it. Push that connector onto the small terminal on the solenoid marked "S". Hope this helps. Good luck.

check the starter and solenoid.take the starter off check to see it rusted or stuck .bench test it with a battery and remote switch.if all good .replace the starter solenoid.

the wire going to the starter follow it down towards passenger fender down this cable depending on the solenoid is either bottom terminal or if solenoid bolts different it is on the right hand side if you are facing the solenoidThe skinney red wire goes to the S marked on the solenoid FOLLOW WIRE COMING FROM BATTERY THIS GOES ON TOP ECT. AS BEFORE ALL OTHER WIRES THAT DO NOT GO TO THE STARTER WILL GO WERE THE BATTERY CABLE GOES .