It will not read anything and do not see any lose wires.
What type of scanner are you using? for a 1996 honda you need to use a obd1 scanner using anything else wont read let me know what type of scanner you have and ill get back to you ,good luck.
Go here for a away around using obd.
http://www.youtube.com/watch?v=8M5BaAa6tCM
In some of the older model cars the OBD was powered by the cigarette lighter fuse lead, Check this first. If that does' not work check your reader in a comparable vehicle and check to see if your reader is a Type 1 plug or Type 2. And if all else fails go to any Advance Auto parts and they will check it for you to see if your plug is reading!
SOURCE: i need 1996 honda accord speed sensor plug wiring diagram
Diagram is courtesy of honda
[IMG]http://i34.tinypic.com/10wjogi.jpg[/IMG]
SOURCE: 1996 Honda Accord Rough Idle Even After tune up
Perform a valve clearance inspection and adjust if necessary. Tight or sticking valves will cause a misfire or rough running concern. Note: Perform valve adjustment when the engine is stone cold. 4cyl: INT 0.26mm EXH: 0.30mm (V6 engine are hydraulic and no adjust necessary.) Also check for a sticking or stuck open EGR valve. For diagnostic purposes only: Remove the EGR valve. Place a business card over the EGR passage and bolt the EGR valve back on. This plugs the EGR ports and if the misfire goes away the EGR valve is partially stuck open and is defective.
Check for low fuel pressure. Check for low compression. Check cam timing. Check for a weak ignition coil. Also don't over look the possibility of worn or broken engine mounts which cause excessive engine movement and engine vibration. -hope this helps
564 views
Usually answered in minutes!
×