2001 Nissan Altima Logo

Related Topics:

A
Anonymous Posted on Oct 15, 2014

I need 2001 altima rear license plate lights

5 Related Answers

Anonymous

  • 726 Answers
  • Posted on Sep 14, 2008

SOURCE: rear license plate lights

do they have covers on them?
if yes they will clip off then 2 screws behind that for the plate

Ad

Anonymous

  • 2 Answers
  • Posted on Sep 17, 2008

SOURCE: Liftgate rear door cover plate for license plate lights.

I used automotive goop.

Seems to be working well

Anonymous

  • 3533 Answers
  • Posted on Jan 04, 2009

SOURCE: how to remove the rear light on my Freestar license plate

in most cases you have to open the rear tailgate remove the panel and then you have access to everything in the door

Anonymous

  • 196 Answers
  • Posted on Jan 08, 2009

SOURCE: light replacement

Just reach behind the bumper and grab the light/electrical harness and twist is either way and then it should pull out put in a new 194 bulb and you are set.

c17hydro

Greg Bernett

  • 2993 Answers
  • Posted on Mar 22, 2009

SOURCE: how to change the license plate light on 2001 ford focus zx3

Take a thin blade screw driver and gently pry between the rubber seal and the metal and pop the light out, replaced the bulb and pop the light back in. works fine.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

MRear license plate light Or fuse on a 2001 Ford Ranger

The license plate lights get B+ power from headlamp switch . No seprate fuse for those lights , Bulb's good ? Headlamps , park lamps all work ?
0helpful
1answer

What is the rear wiring harness for 2001 s-10?

its for the lights mostly..left right tail, brake, backup, license plate..you have brown, yellow, and white, and two shades of green mostly..brown is running(tail/license plate) wire..yellow is left brake, /turn light gren is right side and last wire is reverse..(some may be wrong but its close)..
oh and fuel tank.. sender../pump..not sure of the colors there..I think purple or black..
0helpful
1answer

My license plate lights are not working. I have voltage at the trunk light (11.48 VDC), but not from the two license plate sockets when I turn the headlights on. I uncliped and removed the sockets in order...

could have poor ground wire use 12 volt test light check probe socket positive wire could be grey green wires and touch ground if test light works you have bad ground to license plate lights.and license plates lights have fuse control circuit.
0helpful
1answer

Replace license plate lamp

Junk yard is your best bet. you will have to keep calling until you find someplace with one scraped.
Otherwise, a dealer can get the assemply but it will cost
1helpful
1answer

Rear lights not coming on and interior gauge lights not working

Your taillight/license plate/dash lights fuse is blown. It's all run off of the same fuse.
1helpful
1answer

Where is the backup light sensor for 2003 cadilac deville

Hello: If you mean what turns the back-up lights on, the lights are controlled by the park neutral switch which is mounted on top of the transmission on the drivers side of the car. If you haven't checked the bulbs you need to do that first. Remove the rear license plate, then remove the screws that hold the molding behind the license plate then you can access the bulbs for the back up lights. If bulbs are good check the Park/Reverse fuse in the rear fuse block, if fuse is good check the reverse relay in the rear fuse block. The rear fuse block is on Left side under the rear bottom seat cushion.
1helpful
1answer

2001 LeSabre - replace rear license light. The rear license plate lights do not light up the license at night. How do you get to them? What size bulb do you need?

kind of tricky, took me an hour to get it figured out, but you got to open the trunk and take out the 10 or so 10mm nuts sticking out of the backside of the lid, then the whole solid piece where the lights are on the back will slide off, then you can change the bulbs above the license plate and put it all back together, im cant remember off hand the bulb size, but your local auto parts store will have that info when you go to buy them
2helpful
1answer

How to change the license plate light on 2001 ford focus zx3

Take a thin blade screw driver and gently pry between the rubber seal and the metal and pop the light out, replaced the bulb and pop the light back in. works fine.
0helpful
1answer

Rear license plate lights,How do I change them? I have a Nissan Altima 2002

do they have covers on them?
if yes they will clip off then 2 screws behind that for the plate
Not finding what you are looking for?

48 views

Ask a Question

Usually answered in minutes!

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...