How d I reset not ready monitors

No such thing as resetting an Emission Monitor

What your asking-- is how to clear the dash light--
& ALL Data, you need to diagnose the problems
with monitors that don't run clear, with no problems

First you need to look at the OBD Codes you have
Diagnose those codes & component test & find a problem
& correct it & continue on

Without a Professional Scan Tool your at a disadvantage

If you have cylinder misfires that ruined the converter,then
you have to clean that up & test the oxygen sensors or at
least look at the data

I start with Battery Voltage,Module Voltage,Fuel Trim,MAF Data
& then Mode $06 Misfire Data & Cat Temp & on & on

All but the Evap Monitor should run in about 10 to 20 miles
of driving,not 345

You also have Freeze Frame Data at the time the Monitors
Ran & failed

So NEVER Clear the check light/MIL Lamp, etc
unless ALL issues are fixed & then only if you have to

Fault Codes you need only appear after a monitor runs,
pass or fail,so forget the battery disconnect or code clearing,
you need that data