My son took our holden cruze to pick a friend up and some how lost the key.we have a spare but it dosent start the vehical and we cant afford to get a new one seeing that there six hundred is there any way around this,please help
SOURCE: Charging issue
You need to get yourself a cheap digital voltmeter so that you can check charging voltage. It should be close to 14 volts. Also a repair manual, does the car have an external voltage regulator? If so, change it and check again. Check that the belt is tight! If you have a new alternator and regulator and no charging, it's likely a wiring problem or blown fuse. Scour the wiring diagram and your fuse box(es) for a "charging" fuse.
SOURCE: i lost car key for my car c200
You will need to order new keys from the dealership. A locksmith may be able to make a new one, but if your key has an electronic chip in it, there is no way to copy without original because starting the car depends on that chip.
SOURCE: reprogramming remote and key
if its early 05 round heart shaped remote it needs programming into system at dealer with Tech2
later 05 to 07 had square (rectangle) shaped remote
1.2 ID Code Additional Registration
Note: This procedure will add additional remotes to the Keyless Entry Control Units memory. A total of 4 remote transmitters may be programmed into the Keyless Entry Control Units memory. When a total of registered and newly registered remotes exceed 4, the oldest one shall be erased.
Step Action
1 Note: Make sure that all the doors are closed and unlocked. Insert the ignition key into the ignition switch.
Open the driver's side door.
2 Turn the Ignition key to the “ON” position and then to the “LOCK” position three times
(The key should remain in the “LOCK” position)
Note: This step must be carried out within five seconds.
3 “CLOSE” and “OPEN” the driver’s doors once (Leaving the driver’s door in the “OPEN” position)
Note: This step must be carried out within five seconds after step 2 is completed.
4 Wait for 8 seconds (This wait time is critical)
5 Turn the Ignition key “ON” and then to the “LOCK” position once and turn key to the “ON” position (The key should remain in the “ON” position)
OR on/lock once
Note: This step must be carried out eight seconds after step 3 is completed.
6 “CLOSE” the driver’s door
The HAZARD lights should flash 3 times (This acknowledges the Keyless Entry Control Unit has entered programming mode)
7 Operate the lock or unlock button of the transmitters to be programmed; a flash of the HAZARD lights indicates the remote has been successfully programmed into the control unit
8 The HAZARD lights will flash approx 4 seconds after pressing the remote button to indicate the Keyless Entry Control Unit has exited programming mode.
SOURCE: 1995 Impala SS over heating and fan won't come on.
The fan does not come on until the eng is approx 225f or the a/c is on. When th efan is on and the engine is hot, ck the temp of the air blowing through the radiator, it should be HOT, if its cool or luke warm, the raidator may be plugged.
71 views
Usually answered in minutes!
×