What components have to be removed to remove and replace alternator on a 2006 3.3 town and country mini van.

SOURCE: replace fuel pump on 2005 chrysler town & country.

i cant be avoided sometimes you just have to bit the bullet and remove the tank.

SOURCE: Town and country mini van won't atart

Can you hear the fuel pump run when you cycle the key?

SOURCE: Replacing bulbs in tail lights in a Town and Country.

1. Open your tailgate.
2. Look for two (2) round flat black discs about the size of a dime (but thicker) on the inside of the body (between the red lens and the weather striping).
3. Using a pair of pliers, pull out each of these two discs.
   • Note they are in tight and may require a fair bit of force to remove.
4. Make sure the inner part of the disc also comes out. There are two parts to this system, a grommet and a plug:
   1. Push the plug backwards through the grommet.
      • The grommet fits into the actual hole in the body, and is spread by the plug, the pressure holding them in place.
   2. Carefully remove both grommet and plug.
      • The lens assembly will fall away from the vehicle when you pull out the second grommet so be careful.
5. Note the wiring harness that connects to a plug inside. Beside that plug are two holders for the actual bulbs.
6. Remove the holder by pressing the sides inwards and pulling. The light socket should come out.

Johnny Brown

• 5763 Answers
• Posted on Nov 06, 2009

SOURCE: Replacing a thermostat in 2005 Town and Country Mini Van

yes you are correct.

SOURCE: CHRYSLER town and country mini van turn signal/flasher

I have a 2005 Chrysler T&C. The turn signal would not work at all or activate incorrect side. The switch is easy to remove as described by dukecityman.

Once the switch is of, it has four screws holding it together.I took this apart to find that there was a circuit-board which was contaminated with dirt. wiped it of, put it back together, working fine.

If you take it apart use caution. there are parts on the "top" which will fall out. ( they go right back in) The circuit-board is on the "bottom" half. You really only need to take this part off. (less moving parts)

Your going to replace it anyway, whats the harm?