How do I remove the heater control from 1996 Geo Tracker
The FSM is free
go here
http://www.fixkick.com/
the control is cable drive, why remove that? then each cable end must be removed, and is tedious. (clamps, and other issues)
or do you mean the control switch? set.?
posting the symptom first, puts us on the same page,
so can advise a best path.
see fans switch out here , steps.
http://www.fixkick.com/AirCond/heater.html
or read the fsm.
here is the REAL DEAL
http://www.acksfaq.com/96-FSM-v1-1a-pdf.htm
SOURCE: reset check engine light on 1995 geo tracker
I had the very same problem with my 94 tracker and it turned out to be something simple. My check engine light had popped on after it had hit 100,000. I went through all of the suggestions that people had suggested (unplug battery......etc) and still to no avail. Searching the internet, I came across a website called suzukiforum.com and there, this guy was able to help me with my problem. It turned out to be a maintenance switch that kicks on every 50,000 miles. This switch is like a secret that the auto manufactures use to ploy owners of their cars to bring to the dealer and then rack up the dollars in unnecessary "repairs". The switch is located under the dash and can be hidden anywhere. From the assistance of the guy on the forum, he was able to send me photos of this damn switch and possible locations where it may be mounted. I found mine in about 5 minutes, where it was attached to the steering column. It's a tiny switch, that you slide up or down, depending on what position it is in upon finding it. If it's up, then slide it in the down position and visa versa. Once you do this, the check engine light will go off. Make sure you do not have the car running and you can even unhook one of the battery posts, just to make sure you don't hit anything while rooting around under the dash. Good luck!
SOURCE: Aligning the crank and cam on a 1996 Geo tracker
Use this to align the sprockets, it's critical, you risk engine damage if it is not correct.
SOURCE: 4x4 hub removal on 1996 geo tracker
http://www.kick-fix.com/hubs/hubs.html
with pictures!
Testimonial: "Great information! My biggest question was how to remove the locking hub assembly without damaging anything.This explained it all.The pics helped too."
SOURCE: My 1995 Geo Tracker heater blower dont run,need to
Hello there the heater blower is located under the hood on the firewall on the passenger side you will see a round motor looking item there this is your motor and blower now if you have checked the fuses for this than make sure that the wires that this motor is connected to are all in good condition if so than yes replace the blower motor
ok best regards michael
Testimonial: "Thank you"
SOURCE: 1993 geo tracker fuel injector
ecm does control but is also based on input from the Throttle position senser. unplug the TPS and try again. Also make sure the ECM and engine grounds are good
880 views
Usually answered in minutes!
×