2000 Mitsubishi Montero 5.3 how to remove rear axle shaft
SOURCE: front axle how to remove half shaft
Hi.. The step to remove the front Axles of you Vitara.
Raise and support Vehicle . Remove front wheel,
Drain Diff,fluid,
Remove Locking Hub if is equipaded,
Remove Circle clip from axle shaft
On right side of Vehicle, Remove the Stabilizer Little ball joint nut. Remove castle nut Front Tie rod end,
Remove mounting bolts from brake calipper,
Remove Calipper from steering knuckle and wire a side.
Remove Stud Nut from steering knuckle,
Support Lower suspension arm with a jack,
Remove lower strut bracket bolt ,
Lower jack and disconnect Knuckle from lower suspension crontrol arm,
Pull Outler joint from Hub.
Use Large screwdriver or Prybar To pry Right inner joint from differential, The axle will go out making a little froce with the prybar,
To remove the left side,
Remove mounting bolt from inner joint flange,
Pull out axle from hub.
To reinstall just reverse the prosses.
I hope this help on your job...
Thank you for use fixya....
SOURCE: 2000 MITSUBISHI MONTERO BATTERY CHANGE
manufacturer does not provide a specific computer relearn procedure for obtaining proper driveability . if the battery was disconnected or replaced , driving the vehicle will enable the computer to preform a relearn procedure for obtaining proper driveability , driveability may differ from what you are used to until computer has fully completed the relearn procedure . cheers
SOURCE: Mitsubishi Eclipse Harmonic Balancer 3.0L Removal
There is a panel inside the wheel well that you can take off that gives you perfect access to the harmonic balancer. A special tool is required. i had my dad make one because he has access to whatever he needs at the factory. but you can get them at the dealer. i have no clue how much they cost. I can't see any way of doing it without the special tool. after you get the tool its pretty simple to get off. it takes alot of force to break the bolt loose though. i used the handle off my jack as a cheater bar. hope this helps...
SOURCE: remove rear axles 99 montero sport
this is like every other rear axle they are all built close to the same, you need to pull the wheels, remove the pumkin housing in the center of the axle, inside you will find 2 ring gears with a shaft that goes from top to bottom, on one end there is a cross bolt remove it, then the shaft will slide out and the gears can be removed, not push one axle at a time twords the middle, you will find a horseshoe clip on the end
remove it and that alxe will slide out the end
repeat on the other side, and there you go axles out...
131 views
Usually answered in minutes!
×