Hiya do you know the torque settings for cylinderhead for a bmw 525d e39 2002, 6 cylinder

SOURCE: Cylinderhead bolts torque settings

According to my haynes manual for Landrover 200tdi, G - S reg,1989-1998 it goes as follows,
Stage 1:- Tighten all bolts to 30lb ft or 40Nm then
Stage 2:- Angle tighten a further 60 degrees then
Stage 3:- Angle tighten a further 60 degrees again.

SOURCE: Torque Settings on a 1994 BMW 318i?

The torque settings is more know as torque spec's, and it just means an exact measurement of how tight a paticular part is tightend. With a new engine, many differnt parts have differnt specs, but hands down the single most important thing would be the cylinder head to engine block torque. This is often done in a 3 step process, using a torque wrench, and a torque angle gauge. Are you planing on installing an engine yourself? I can get specs for you.

SOURCE: Hi I'm looking for cylinder head torque settings for a 1992 BMW 316/318 e36

BMW cylinder torque setting all models

According to my service manual as follows.

Cyl head to engine block (torx e12 M10 bolts)

Stage 1 30nm (22 ft – lb)
Stage 2 + 90 degrees
Stage 3 + 90 degrees

Cyl head to lower timing chain cover 10nm (89in – lb)

The tightening sequence is from inside to outside crossover as normal. Loosening sequence is from outside to inside crossover. Remember to set torque wrench at low setting and work gradually up through the whole sequence until you get the desired torque.

SOURCE: torque setting cylinder head bolt 4 cylinder KIA sportage

I need the torque settings and pattern for a Kia Sportage 2.2

steve morris

• 1675 Answers
• Posted on Mar 21, 2010

SOURCE: CYLINDER HEAD TORQUE SETTINGS BMW 318TI THANKS

hi this has to be done in 3 stages, leaving 20 to 30 minutes between tightening's they are as follows..
stage 1: 30Nm leave 30 minutes stage 2: 90 degrees turn leave 20 minutes stage 3: 90 degrees turn leave 20 minutes
you have to leave them this length of time so as not to put to much strain on the head in one go...hope this helps please vote thanks