How do I replace the ignition module on a 1989 Oldsmobile Cutlass? Where is it located on the engine? The engine started but would not continue to run. No sputtering or any other sign it is going to cut off. Does the ignition module have a fuse?
SOURCE: 1996 Oldsmobile Cutlass Ciera car runs then idles low and sounds like engine is dying
check the convertor for clogging. you can also do a back pressure test on the convertor to determine if it is bad.
SOURCE: 1989 oldsmobile cutlass ciera car starts but won't stay running it sputters and backfires and dies
Hello dear
I have the same problem and i checked the knock sensor should give you a code 43!!! Disconect the connector of knock sensor and with multimeter you should get 4-6 volt with ground!!
Plsss contact me at [email protected] to disscus more about our problems !!
Regards
238 views
Usually answered in minutes!
×