Install front bumper spoiler 2004 toyota matrix

SOURCE: how to change oil in 04 toyota matrix

Go to Walmart buy four quarts of oil it will say in the owners manuel what to get, a oil filter the store will have a book to look up the car know the engine size and model,a filter wrench, a drain pan and a jack to carefully jack up the front area of the passenger side of the car . I use a old rag and double fold it so the jack dosent mess up the jack point of the car. It will tell you also in the owners manuel where to jack it. PLEASE do not use the factory jack to go under the car buy one. OR go to the dealer and ask for a oil change coupon or go to Goodyear .

SOURCE: 2005 toyota matrix rotor removal

The Matrix rotors are the Knock Off type.

SOURCE: How do you change the head lights on a Toyota

You access the bolts fron the inside of the hood, there are 4 bolts holding the headlight unit, remove them and pull the assy out.

SOURCE: Location and how to fuel filter for 04 Matrix

Fuel filter is in the tank. Attatched with fuel pump

SOURCE: how to replace toyota matrix front headlight bulb

Hi,

Replacing a headlight on a Toyota Matrix is a simple process that only requires the use of a screwdriver and a replacement bulb. The Matrix uses 9006 bulbs for the low beams and 9005 bulbs for the high beams. Headlight bulbs can be purchased at auto parts stores.
Replacing Low Beam Bulb

1. Turn off the engine of the Matrix and open the hood
2. Rotate the bulb base in the headlamp assembly counterclockwise to remove the low beam bulb. Unplug the electrical connector. If the connector is too tight, wiggle it slightly to help remove it.
3. Install a new bulb into the connector and place it into the assembly. Rotate it clockwise to lock it into place. Close the hood.

1. Turn off the engine of the Matrix and open the hood. If replacing the left-hand headlight, remove the air cleaner duct by removing the securing clip with a screwdriver and pulling the duct out of the vehicle.
2. Turn the bulb base counterclockwise to remove it. Unplug the electrical connector.
3. Install a new bulb into the connector and place the bulb into the assembly. Rotate it clockwise to lock it into place. Reattach the air cleaner duct if replacing the left-hand headlight. Close the hood