How to replace horn on 2002 buick le sabre

SOURCE: procedure to repaloce rear shocks

Removal & Installation

1. Remove the tire and wheel assembly.
   
2. Support the control arm with a jack stand.
   
3. Remove or disconnect the following:
   
4. Electronic Ride Control (ELC) air tube from the shock
   
5. Two bolts securing the shock to the control arm
   
6. Trunk trim to gain access to the shock upper mounting nuts.
   
7. Cover, the two nuts, and the reinforcement from the top of the shock
   
8. Shock from the vehicle
   

SOURCE: Where is the egr valve in a buick le sabre

The EGR Valve on this 3.8 L engine should be in front of the throttle body on the drivers side of the engine just to the right of the front valve cover. If you locate where the intake tube/duct attaches to the throttle body and then move just a few inches toward the front of the car it should sit right in that spot. It will have two bolts attaching it to the intake/tube. Hope you find it!!

SOURCE: HOW MUCH SHOULD IT COST TO REPLACE A FUEL PUMP IN

its just a gestament based on my experience with the cost of submersible electric tank pumps costing around $150 so allow around 200bucks for pump & labour although some pumps are over $300
Cheers rob.

SOURCE: Where's the fuel filter on 2000 Buick Le Sabre and how to replace

release the pressure firs like take gas cap off there are some speacil tools called quick release tools some people just use a small screwdriver to pop it off it should be on driver side by the drivers door under neath the car if its a four door this driver door im talking about

SOURCE: how to replace left front

Headlight Removal & Installation Bulb Replacement CAUTION
Improper handling of a halogen bulb could cause the bulb to shatter into flying glass fragments due to the bulbs containing gas under pressure. Always wear eye protection, only handle the bulb by its base, keep dirt and moisture off the bulb, do not install the bulb with power at the socket, and keep them away from children.

To Remove:

1. Turn off power to the headlamps.
2. Remove the headlamp assembly.
3. Turn the bulb socket counterclockwise and remove from the headlamp assembly.
4. Remove the bulb from the socket.

1. Install the bulb into the socket.
2. Install the bulb into the headlamp assembly and turn clockwise to lock into place.
3. Install the headlamp assembly.

1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
2. Open the hood.
   
3. Remove the fasteners (D) that retain the headlamp assembly (C) to the headlamp bracket (A).
4. Pull the headlamp assembly (C) forward in order to disengage the rear retaining pin (B), and disconnect the electrical connector from the forward lamp harness.
5. Remove the headlamp assembly from the vehicle. NOTE: Avoid touching the bulb or letting the bulb come in contact with anything damp. Oil from your skin or moisture on the bulb can cause the bulb to explode when the bulb is turned on. If either comes in contact with the bulb, clean the bulb with alcohol or a suitable degreaser and wipe the bulb dry.
   
6. Remove the bulbs from the headlamp assembly by turning them counterclockwise.

1. Install the bulbs into the headlamp assembly and turn them clockwise to lock in place.
2. Connect the electrical connector to the forward lamp harness.
3. Install the headlamp assembly (C) into the vehicle by pushing rearward in order to engage the rear retaining pin (B).
4. Install the fasteners (D) that retain the headlamp assembly (C) to the headlamp bracket (A).
5. Close the hood.