How can i reset maintenance required light on 2007 toyota prius

SOURCE: Reset the maintenance required light on my 2008 toyota corolla

OK ON YOUR SPEEDOMETER, THERES TRIP A, TRIP B, AND THE REGULAR ODMO... U NEED TO PUT IT ON TRIP A (WITH THE KEY OFF) ONCE U GET IN ON TRIP A, PUSH AND HOLD THE BUTTON DOWN,WHILE HOLDING BUTTON DOWN TURN KEY ON, YOU WILL SEE LINES POP UP ON THE ODOMETER, (WHERE THE MILES ARE DISPLAYED) THEY WILL GO OUT ONE BY ONE, ONCE IT STATES 0 YOU ARE GOOD TO GO.. GOOD LUCK AND THANK YOU FOR USE FIXYA.COM..KEITH..

SOURCE: How do i reset the maintenance required light

1. Turn the ignition key to the “OFF” position
with the odometer reading shown.
(For details, see “Odometer and two
trip meters” on page 145 in this Section.)
2. Turn the ignition key to the “ON” position
while holding down the trip meter
reset knob.
Hold down the knob for at least 5
seconds. The odometer indicates “000000”
and the light goes off.
If the system fails to reset, the light will
continue flashing.









To reset the Maintenance Lamp turn the car key to ON (not start), set your odometer on mileage (not trip a or b), then depress and hold the button that switches from odo and trip then turn key off. Turn the key back to ON, while you are holding the button down you will notice the maintenance light blink and go out. Reset is complete and you are done.


These are available in your owners manual for the vehicle.


Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.

SOURCE: what does the

Maintenance light is turned on when your vehicle is due for service. It is set to turn on at a certain mileage. At minimum, you need an oil change service and what ever is required at your mileage interval. Resetting the light is as simple as, Ignition Key in the off position, press and hold the odometer button, Turn the ignition key on and continue to hold the odometer button for at least ten seconds. If properly done, you will see dashes across your odometer as you hold the button, until the odometer reading reappears. Hope this helps. Please leave feedback.

SOURCE: Reset Maintenance Required on 2007 Toyota FJ

turn ignition to "on"; set your odomoter trip meter display to trip "A" turn off the ignition; hold down trip reset button while turning ignition back to "on" position; hold the button for around five more seconds until it shows a full display of zeroes (ex. "00000000") light should procede to turn off

SOURCE: how to remove maintenance required light?

With the key in the off position, hold down the trip reset button and turn the key on. You will see 5 lines across the odometer display that will count down. Continue to hold the button until all the lines have counted down and the light will be reset.