Does any one have instructions or a diagram on how to replace the water pump in a 2002 ford taurus v6 3.0l thank you for your responses kinda need them as soon as possible
Removal & Installation
3.0L (2V)
To Remove:
To Install:
Water pump bolt torque sequence (3.0L (2V) engine)
3.0L (4V)
To Remove: Before servicing the vehicle refer to the precautions in the beginning of this section.
Drain the cooling system.
Raise and support the vehicle.
Remove the right front splash shield.
Disconnect the hoses from the water pump.
Lower the vehicle.
Remove the accessory drive belt.
Disconnect the upper hose from the water pump.
Remove the A/C compressor support brace.
Remove the four mounting nuts and the water pump.
To Install: Position the water pump and install the mounting nuts. Tighten the nuts to 18 ft.-lbs. (25 Nm).
Install the A/C compressor support brace.
Connect the upper hose to the water pump.
Install the drive belt.
Raise and support the vehicle.
Connect the hoses to the water pump.
Install the splash shield.
Fill the engine cooling system.
×
6,669 views
Usually answered in minutes!
×