Disconnect battery, locate starter wires [should be 3] make particular note of how wires are connected, then remove the two nuts that hold them in place, loosen and remove the two bolts keeping hold of starter to prevent it falling and remove starter. Replace new starter and it's two bolts, wires and nuts as previously hooked up, and then battery wire, and carank vehicle.
SOURCE: where is pcv valve 1998 buick lesabre
Remove the sight shield from the fuel rail. (it's the large plastic shield that dresses up the engine) As you stand in front of the car the alternator is located on rear left side. In front of it is an electrical connector to the MAP sensor. Remove it. Press the PCV valve cover down and rotate it 1/4 turn counterclockwise. It is actully on the intake manifold. Lift the cover, the upper O-ring and the spring from the housing. Remove the pcv valve and the lower O-ring from the intake manifold.
389 views
Usually answered in minutes!
×