SOURCE: 1999 mercedes ml320 brake lights don't work
did you check to make sure the wires going to the pedal switch are not cracked or burnt?
SOURCE: brake lights/rear turn signals
I had the same problem with my 1999 Yukon. The electric board needed to be replaced. Rust starts to build up and shorts out or blows the bulb. The dealership charged $73.60 for the part and I installed it myself (Saved $30).
SOURCE: Brake lights quit working.
if all fuses and bulbs are ok get to the brake switch and see ifits stiff or stuck, if it just has two wires on it you could join themtogether to see if the brake lights come on though obviuosly dont leave them joined.Good luck davelee
SOURCE: Brake lights don't work. Replaced bulbs, checked
Yes, you need to of course check the voltage coming into and going out of the brake light switch, if 12 Volts are there going out and coming in while pressing on the brake pedal, your brake lights aren't getting a good ground or there is a break in the circuit between that switch & the lights.
On occasion the tail lights will work with a weak ground circuit where the Brake lights won't. Best way to determine this is to just hook up the 12 volt tester to the Brake light hot wire & there at the bulb ground, then in an area away from the bulb that has a good possibility of contact/ground.
Really that's it, if the 12Volts is getting to the bulb but it isn't lighting, if you aren't getting the voltage there and the brake switch is hot on both sides when pressed, the break in voltage will have to be traced from that switch to the tail light to find the problem.
good luck.
553 views
Usually answered in minutes!
×