How do i fit a drive belt?

Hi Robert:
The make and model might help one of us to google it and find an answer, but if you have the correct belt, replacement is a straightforward matter.
- Vee belts fit in the vee and are tightened by loosening the alternator bolts and moving the alternator.
- Serpentine belts have the inside (ridges) fit into the drive and driven pulleys, and the outside fits against idler pulleys and the tension pulley. The easiest way to install that I have found is to use a 3/8 tortion bar with a "cheater" extension on the handle. (mine is a piece of square aluminum tubing about 2 ft long. The 3/8 square drive fits in a hole in the face of the pulley carrier. Move the tensioner pulley so that it is in the fully slack position, and while holding it there, put the serpentine belt in place. Then let the tensioner release to tighten up the belt.

-Always follow its repair manual.

Good Luck

Mai

Is the drive belt still fitted? If so draw a diagram of all the pulleys connect the pulleys in your piccy with lines as per your belt run on the engine.There may be an automatic tensioner you will require a tool to operate this You should be able to replace the belt now. Hope this is helpful.

CHECK UNDER THE FRONT HOOD OF THE FRONT HOOD.

Start by drawing a diagram of the belt routing. Serpentine belts normaly have 1 spring loaded tensioner (1 pully will have a nut or 3/8 or 1/2 inch drive hole) That will be the tensioner. get spanner or ratchet to fit & lever the tensioner away from the belt. Remove belt. fit new belt to most pullys except the easiest to get to, lever the tenioner back & fit the belt to the last pully, Check the belt is on all pullys properly & your done

Below is the master help link provided to go through belt routing diagram:---Timing belt, drive belt, serpentine belt, accessory belt, fan belt, engine belt routing diagrams for all types of car models?
Click the link below: ----

http://carbeltrouting.blogspot.in/2012/02/timing-beltdrive-beltserpentine.html
----------This will help. Thanks.

For all types ofTiming belt routing diagrams for cars and trucks?Click the link below:---http://technoanswers.blogspot.com/2011/10/timing-belt-routing-diagrams-for-cars.html
For all types of Drive belt routing diagrams for cars and trucks?Click the link below:---http://technoanswers.blogspot.com/2011/10/drive-belt-routing-diagrams-for-cars.html-------------Thanks.

Here is a diagram for fitting the serpentine belt to your CamryPlease rate this solution.

If its not the required one then please write your engine code.
http://www.gigasize.com/get.php?d=0zkocl562ff

for the most part there is a diagram under the hood but give this website a try Drive belt Diagram www.webcrawler.com wish you the best of luck Michigan Man.