Honda engine d12y8 crank torque sequence 1996 civic

SOURCE: Replacing head gasket on 1995 honda civic, require torque specs and secquence

wow. a lot of bad information on this site. Refer to a manual for the proper torque sequence. The civic I believe is a two step torque procedure. First 22 ft lbs, than 53 ft lbs.

SOURCE: How to change upper control arm on 1996 Honda Civic DX ?

UPPER CONTROL ARM:

Do not disassemble the upper arm. If the ball joint or bushings are faulty, or the upper arm is damaged, the entire upper arm must be replaced.

1. Raise and support the vehicle safely.
2. Remove the front wheels. Support the lower control arm assembly with a floor jack.
3. Separate the upper ball joint from the steering knuckle using a ball joint separator tool.
4. Remove the self-locking nuts from the upper arm anchor bolts. Remove the upper arm from the vehicle.

1. Install the upper control arm assembly into the strut tower.
2. Connect the upper ball joint.
3. Install the front wheels and lower the vehicle.
4. With all four of the vehicle's wheels on the ground, torque the upper control arm nuts to 47 ft. lbs. (65 Nm). Torque the castle nut to 32 ft. lbs. (44 Nm); then, only tighten it enough to install a new cotter pin.
5. Tighten the wheel nuts to 80 ft. lbs. (110 Nm).
6. Check and adjust the vehicle's front end alignment.

1. Remove the lower control arm that is in need of new bushings.
   

1. Set up the control arm in a press.
2. Using a impact socket of the correct length and size, press out the old bushing.
3. Install the new bushing by slowly using the press to push it into the control arm.
4. WARNINGExcessive force could cause the bushing to bend or tear so be careful.
5. Once the bushing is properly seated in the control arm, remove the arm from the press and install it on the vehicle.

SOURCE: fuse diagram for 1996 honda civic

try this link... let me know if this is what you needed... http://img530.imageshack.us/img530/8770/9600civicfuse98civicexatb2.jpg

SOURCE: 1996 honda civic dx interior dash lights turn, headlights on.

it is more than likely a short in the headlight switch. also try the dimmer switch on the dash for the dash lights.

SOURCE: i need the engine torque specs for 99 chevy malibu

99 chevy malibu v6 3.1 engine, head bolt torque is-- 98 through 2001 is step1- 37 foot lbs, step 2- rotate an additional 90 degrees (1/4 turn). the rocker arm bolts are 168-in. lbs.