I turned on wipers and they do not move, the motor works but the linkage plastic covers or clamps broke off, now I do not know how they go correctly
SOURCE: 1993 Dodge Dakota Windshield wipers stopped
There are bushings that go bad. They are available from a parts store. Ask or look under the HELP! section. the cowl panel will need to come off. replace ALL of the bushings.
You posting is slightly confusing but I gather your windshield wipers stopped working.
The repair method is as follows;
) Check the fuse.
) Check the wiper motor. Turn the wipers on and listen for the hum of the motor.
If you hear the hum then the linkage has probably come loose. You will have to take the covers off
to get to the linkage for the wiper. You can either repair the parts, get salvage yard parts or replace with new part$.
If you do not hear the motor hum then you should verify electricity is getting to the motor. A simple
voltmeter can be used. If the motor is bad you can replace it. Call some auto supply stores for after-market motors or call salvage yards for parts.
SOURCE: windshield wipers make loud noise but dont move when turned on
Probably stripped the little splines where wiper arm attaches to pivot. Flip the cover up where arm attaches to pivot, and tighten nuts on there, but be careful not to go too far, its not hard to snap the pivot stud if you tighten too much. make sure wipers are off, in park position, and move arms to where they should be, then tighten. See if you still get loud noise after. If you do, somethings wrong under cowl, in the linkages or motor. You may be able to see something with flashlight or troublelight.
SOURCE: Windshield wipers don't work but the motor runs . 93 Dodge Dakota
remove wiper arms and then you can raise the hood to remove screws that hold down the vent panel.
now carefully remove vent panel.
SOURCE: 1996 dodge grand caravan windshield
the linkage could have come off the motor itself there is a locking clip that sometimes breaks and allows the linkage to come off.you would have to remove the under hood cover to gain access to the motor along with the removing the wiper arms to remove the assembly so you can work on it there is the washer hose that will have to be removed also.
238 views
Usually answered in minutes!
×