Where is the oil sending unit located on a Dodge

Located on the lower front side of the engine block. And it screwed into the oil filter adapter.

Need engine size for specific information. Mike

You might want to check beside the oil filter. This is usually the location on some older models

make sure are using a genuine dodge oil filter and correct grade of oil to check further you need to have the oil pressure checked using a master gauge a garage would do this for you if ok replace pressure switch if very low could be pump and bearing wear is the idle speed set too low i would check this

The Oil Sending/Pressure Unit is located directly to the Left of the Oil Filter. It should have only one wire going to it.
Let me know if this helped, or if you have additional information or questions. Feel free to contact me at FixYa.com!

I belive the oil pressure switch is located by the oil filter on this unit.

oil pressure sending unit show location on 2000 dodge caravan V-6

this is normally located near the oil filter but if you get the part at auto zone they can give you a diagram showing you the exact location

HI..
ON your Dodge caravan 3.0 L
The oil pressure sensor is Located On the base of the OIL FILTER. Near the starter motor.

I hope this is the information that you looking for.

Thank you for use fixya. Rate this solution. please.

It's located near the oil filter, it's round with a 2 prong plug attached. The radiator side of the block, below at right of oil filter.