How to clean egr valve 2000 Mazda - 2000 Mazda 626

francisco navarro

• 241 Answers
• Posted on May 28, 2008

SOURCE: EGR VALVE

REMOVAL PROCEDURE

1. Turn OFF the ignition.
2. Disconnect the EGR valve electrical connector.
3. Remove the bolt retaining the pipe assembly from the EGR valve and carefully pull the pipe assembly back.
4. Remove the EGR valve retaining bolts.
5. Remove EGR valve assembly.
6. Remove the gasket.

1. Install the EGR valve with a new gasket to the intake manifold. NOTE: Refer to Fastener Notice in Service Precautions.
2. Reinstall the bolts through the EGR valve into the intake manifold. Tighten Tighten the EGR bolts to 30 N.m (22 lb ft).
3. Connect the exhaust pipe assembly to the EGR valve.
4. Reinstall the exhaust pipe bolt. Tighten Tighten the nuts to 30 N.m (22 lb ft).
5. Connect the EGR valve electrical connector

SOURCE: 2000 mazda miata r&r throttle body

se if egr is controled by vacium or electric
if it is by vacium then locate the egr solenoide and make sure it has vacium in one hose w/ engine runing if it does then replace solenoide

SOURCE: How do you replace the EGR valve on a 2000 Mazda

if you are lockey to have one it is on the intake manifold two bolts or three depending on the engine and some have a tube / and eather vaccum or electric wires attached // if you don't have an egr try changing your o2 sensors ( some manufactures use the o2 sensors as the up & down stream and have removed the egr valve

ZJ Limited

• 17989 Answers
• Posted on Jun 25, 2010

SOURCE: were is the egr valve located for mazda rotege5

2002 Mazda Protege5 with the FS2.0 Motor. The EGR Valve is located below the throttle-body. You must take off the Intake tube to get a good view of it. To replace it I think you might have to take off the throttle-body.



Fig. Exploded view of the intake manifold assembly with 2.0L (FS) engine

Good luck (remember rated this).