How do you remove the dashboard off of a 2007 Lincoln Town car? I have to replace the analog clock bulb .

That sounds like a blown fuse, but your vehicle also has 'lighting modules'.

2003-2011 Lincoln Town Car Fuse Box Diagram

https://knigaproavto.ru > shemy > 607-2003-2011-linc...
Jul. 22, 2018 - Fuse Box Diagram Lincoln Town Car S, D, E, C, U (2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011)


..

Quoting from link:

https://itstillruns.com/replace-lights-lincoln-town-cars-7660993.html

Tail Lights, Stop Lights and Rear Turn Signal Lights

Turn the Town Car's engine off, and open the trunk. Remove the trunk retainer if your Town Car is equipped with one. Put on the gloves.
Pull the carpet away in order to access the tail lamp assembly. Remove the three nut-and-washer assemblies with a socket wrench.
Remove the desired bulb socket by turning it counterclockwise, and then pulling it straight out of the assembly. Pull the old bulb out of the socket, and install a new bulb. All three lights use 3457AK-type bulbs.
Place the socket back into the assembly, and reinstall the three nut-and-washer assemblies. Place the carpet back into the vehicle, reattach the trunk retainer if necessary, and close the trunk.

https://itstillruns.com/replace-lights-lincoln-town-cars-7660993.html

Hate to tell you this, but you will need to remove the entire dashboard to access the heater core.

http://www.ebay.com/itm/Lincoln-Town-Car-Dash-Analog-Clock-LIGHT-BULB-1-Qty-2003-2011-/281523990020?pt=Motors_Car_Truck_Parts_Accessories&hash=item418c232e04&vxp=mtr

If that clock is digital read out lights you might have to replace whole clock if not you will have to take dash apart to get to it,Overhead should have visable screws to take out to release lite cover,

Its an 11 hr job bring it to a dealer about $800

ouch..this is a big job..if you are not familiar with. can do some damage

assuming this is the digital clock, you hit the clock button on the dash, followed by the reset button followed by the clock button. at this point, you should be able to hit the clock button to advance numbers, and the reset button to change the numbers you are setting. if its the analog clock, pull on the knob and turn it

you need a special tool to get the radio out. It has pins that spread out spring clips so the radio can pull out.

please rate as solved if this helps.

SECTION 413-00: Instrument Cluster and Panel Lighting — General Information 1999 Town Car Workshop Manual
REMOVAL AND INSTALLATION Bulb —Electric Clock
Special Tool(s) Radio Removing Tool
T87P-19061-A


Removal

1. Disconnect the battery ground cable.

1. Pull out the radio using Radio Removing Tool.

1. Remove the radio.
   1. Disconnect the electrical connectors.
   1. Disconnect the antenna cable.
   1. Remove the radio.

1. Remove the instrument cluster finish panel bolts.

1. Remove the instrument cluster finish panel bolts.

1. Pull out and position aside the instrument cluster finish panel.

1. Disconnect the electric clock electrical connector.

1. Remove the instrument cluster finish panel.
   1. Disconnect the headlight switch electrical connector.
   1. Disconnect the dimmer switch electrical connector.
   1. Remove the instrument cluster finish panel.

1. Remove the electric clock illumination bulb.

Go to Autozone and purchase a Clymer repair manuel. It will show how to remove the dash. You need to find all the screws.