How do you replace a pcv valve on a ford 1991 LTD Crown Victoria
Its located at the back of the engine near the firewall. it has a large hose connected to it(3/8") if I remember right. it is attached to top of the PCV valve. pull the hose off then you can pull the valve out of the rubber grommet that holds it into the engine.
SOURCE: need wiring diagram for 2008 ford crown victoria
Hello,
You can purchase the wiring diagram for $5.99 from the following site: http://www.wiring-diagram.com/. You can also purchase a wiring diagram book from the following link: http://cgi.ebay.com/ebaymotors/2008-FORD-CROWN-VICTORIA-MARQUIS-WIRING-DIAGRAM-MANUAL_W0QQitemZ120394723100QQcmdZViewItemQQimsxZ20090320?IMSfp=TL090320147007r15080.
Hope this helps,
Chris
SOURCE: Where is the fuel filter located on a 1986 Ford
Located in right rear under a red cylindrical plastic cover held on by 2 8mm screws
SOURCE: odometer on 1991 ford ltd
Hi. I am assumming that the speedometer is still working. If that is the case, it's the vehicle speed sensor that is failing. The vehicle speed sensor, which is mounted in the transmission, creates an electrical signal that is used by both the vehicle’s engine computer, speed & odometer. Failure of this sensor is not uncommon, is not costly and is easily replaced. It would be best to take your vehicle to the repair facility when the problem is occurring. This allows diagnosis to confirm the need of the parts being replaced.
SOURCE: Would you please let me know where the PVC valve
The Positive Crankcase Ventilation valve is in the valve cover. It sticks up a bit, and has a hose running to it.
357 views
Usually answered in minutes!
×