How do I replace crank shaft position sensor in a 1997 Lincoln town car?

SOURCE: fuel pump in a 1997 town car

i have successfully fixed my problem. the pump is located at the front of the fuel tank and is accessible without, i repeat WITHOUT removing the tank.

SOURCE: 2005 Subaru Baja Crank Shaft Position Sensor

is there a problem using e10 ethonal in a subaru impreza wrx 2003

SOURCE: CRANK SHAFT POSITION SENSOR 20002 NISSAN ALTIMA

1st, Nissan had a recall on Crank position sensors for 2002-2006 Altima's. Check with you dealer before you go doing any repairs. You may discover you can get your car repaired at no charge.
NHTSA Campaign ID number :O7V527000
Symptom: Erratic behavior. Stalling and no starts and very difficult to diagnose due to the time frame in which the component actually malfunctions. The warranty should not be limited to the original owner.
I would also need more specifics as to which engine you have so I might assist you in where the location of the sensor is. The Altima had a 4 and a 6 cyl engine offered that year.

SOURCE: 1997 lincoln town car 4.6 with a p0430 fault code

I will make an assumption here, we know what the root word means. This code was extracted from the computer by? What this is telling you one of 2 things: The Bank 2 oxygen sensor down stream of the catalytic converter (there are 2 converters, one for each bank of cylinders on the 4.6ltr engine) is bad and/or that the Bank 2 catalytic converter is no longer doing the job it was designed to do. Simply, Catalysts wear out. They are good for approx 100,000 miles (as required by Federal Law). Again, I assume that the reason the intake manifold was replaced was because it had a crack in one, or more, of the runners? (part that feeds the head of a manifold). It may have taken a while to find this as being the cause of why the car running incorrectly, maybe rough. This means, that during the time the car was being driven with the problem, the amount of unburned, or not within spec exhaust gases, coming off the side of the engine affected by the intake issue was higher than normal. This out of balance level of exhaust gases were being dumped into the converter on that side of the engine, thus causing the converter to have to run hotter, work harder, or even at the time the gas was being processed through, causing deposits to be formed in the converter, thus shortening it's life span. The Bank 1 side of the engine, apparently, did not have the issue and it's catalytic converter's life was not affected. I hope this makes sense to you.

Mike Butler

• 6674 Answers
• Posted on Sep 05, 2009

SOURCE: crank shaft position sensor needs replacing in 96 Chevy cavalier

Try this.