Windshield wiper control module on a 2003 lincoln

http://knigaproavto.ru/shemy/en/lincoln/town-car/607-2003-2011-lincoln-town-car-fuse-box-diagram.html

Have a qualified repair shop check it out . Electronic module involved , WCM - wiper control module . May have code's stored . You have no clue as to how it works.

The windshield wipers are controlled by the wiper control module and the driver-operated multi-function switch on the steering column, with the ignition switch in RUN or ACC position.
There are four modes of wiper operation: OFF position, the wipers move to and stay in the park position; Interval position, the wiper control module causes the wipers to cycle, separated by pauses, pause time length being determined by switch location; LO position, the wipers will operate at low speed continuously; HI position, the wipers will operate at high speed continuously.
The windshield washers are controlled by pressing inward on the wiper switch end of the multi-function switch. The washers will operate as long as the switch is depressed. If the wipers are in the OFF or Interval operating mode, the wipers will begin in LO speed and the washer pump will pump fluid from the reservoir to the nozzles. When the switch is released, the wipers will complete three cycles and then return to their previous setting. In LO or HI mode, no change in wiper operation will occur during washer operation.
The washer fluid level sensor is in the windshield washer reservoir (17618) and is monitored by the hybrid electronic instrument cluster (HEC) and displays a WASHER message when the fluid level is low. The washer fluid level sensor and windshield washer reservoir are replaced as an assembly.

• The Low Wiper Speed Does Not Operate Properly

• Multi-function switch.
• Wiper motor.
• Circuitry.
• Wiper control module.

• GO to Pinpoint Test C .

• The High Wiper Speed Does Not Operate Properly

• Multi-function switch.
• Wiper motor.
• Circuitry.
• Wiper control module.

• GO to Pinpoint Test D .

First off you need to do some testing to see what needs replacing !

• Windshield Wipers Will Not Park at Proper Position

• Damaged windshield wiper motor.

• Damaged windshield wiper control module.

• Damaged circuitry.

• GO to Pinpoint Test E .

Do you know how to do electrical testing ?
PINPOINT TEST E: WINDSHIELD WIPERS WILL NOT PARK AT PROPER POSITION E1 CHECK WIPER MOTOR GROUND

• Disconnect connector from windshield wiper motor.
• Check continuity to ground at Circuit 57 (BK).

Is ground OK? Yes No GO to E2 . SERVICE open in Circuit 57 (BK). RESTORE vehicle. RETEST system. E2 CHECK FOR POWER AT WIPER MOTOR

• Place ignition switch at RUN and multi-function switch at OFF.
• Check for battery voltage between Pin 1, Circuit 65 (DG) and Pin 4, Circuit 57 (BK) at the windshield wiper motor connector.

Is B+ present? Yes No GO to E3 . SERVICE open circuits. RESTORE vehicle. RETEST system. E3 CHECK MOTOR CIRCUIT CONTINUITY THROUGH WINDSHIELD WIPER CONTROL MODULE

• With multi-function switch at OFF, check continuity between Circuit 28 (BK/PK) and 56 (DB/O) and between Circuits 61 (Y/R) and 63 (R).

Is continuity OK? Yes No GO to E5 . GO to E4 . E4 CHECK CIRCUITS TO WIPER CONTROL MODULE

• Disconnect wiper control module connector.
• Check continuity of Circuits according to the chart below from the wiper motor to the wiper control module.
  
  Wiper Control Module Connector Wiper Motor Connector Pin Circuit Pin 6 Pin 2 28 (BK/PK) Pin 8 Pin 6 56 (DB/O) Pin 12 Pin 5 61 (Y/R) Pin 13 Pin 3 63 (R)

Is continuity present? Yes No REPLACE wiper control module. RESTORE vehicle. RETEST system. SERVICE open circuits. RESTORE vehicle. RETEST system. E5 CHECK WIPER MOUNTING ARM/PIVOT SHAFT

• Check that windshield wiper mounting arm and pivot shaft and linkage is not bent, cracked or mis-positioned.

Is windshield wiper mounting arm and pivot shaft linkage OK? Yes No REPLACE windshield wiper motor. RESTORE vehicle. RETEST system.

Wd40 of gt85 tray that first

located under dash at drivers right knee area

the wipers are controlled by the lighting control module

THERE IS AN INTERMITTENT WIPER MODULE [ BLACK BOX ] BEHIND THE DASH, ON THE DRIVERS SIDE. APROX. IN LINE WHERE YOUR RIGHT KNEE WOULD BE, JUST ABOVE THE AIR BAG MODULE.
WIRE COLORS ARE
ORANGE
DK. GRN.
BLK.
BLK--PINK
BRN--WHITE
DK BLU--ORANGE
YEL--RED
RED
WHITE

It may be the windshield wiper module instead of being the motor, since you have had that replaced 3x already. There should be no fuse issue.

where is the fuse box for my 2001 lincoln towncar looking for windshield wiper fuse because they wont turn on what so ever