1998 Toyota Corolla Logo

Related Topics:

A
Anonymous Posted on Sep 17, 2014

What year trim panels fit a 1998 toyota corrolla

I have a 1998 toyota corlla need to know what years will fit

5 Related Answers

Anonymous

  • 30 Answers
  • Posted on Sep 03, 2008

SOURCE: How do I remove the

ffirst remove all screws that are holding it on approx 10, most are hidden by small round circles of plastic the same colour as the panel next you to be firm and pop it off from the door carefully there is about 10 of these clips which "pop" off then carefully lift upwards slighty unplug your electric window switch by pushing the tab on the plug itll come off. that's your door panel off. be carefull not to bump and of the metal wires you see running inside the door as these are to do with you door lock. to fix window gently pull down plastic moisture sheet on door first try another switch or give your switch a good clean, you can disasssemble it with a small screwdriver carefully, if still no difference replace your electric window motor which is bolted to the door in 3 places with 10mm bolts and is bolted to the window, unsure of what it is follow the wiring from the electric switch you unplugged will lead you to the electric motor, have fun

Ad

Anonymous

  • 716 Answers
  • Posted on Jan 06, 2009

SOURCE: 1998 Toyota Camry Inside Door Handle

The Door Panel Has Got To Be Removed.
Start By Removing The Handle Cover You Mentioned On The Handle Careful Not To Break It . A Small Screwdriver Can Help.
Next Remove Black Piece By The Window By Pulling It Strait Outward. Then Remove The Screw Cover On The Actual Handle You Use To Close The Door. Remove The Screw From Below It And There Is One Under The Front Edge Of It As Well. There is 2 screw along the bottom edge of the door as well. then remove screw up by the mirror. now remove this little plastic clip right on the side closest to the outer edge by pressing the center and pulling the whole thing out. Then There Are 2 10mm screw that hold on the door latch remove and slide the whole handle forward and it should come free. Now Reverse all these steps with the new handle in place.
THIS SEEMS HARDER THEN IT IS I PROMISE.
If You Have Any Questions What So Ever Please Feel Free To Post Then And I Hope I Helped At least A Little.

Anonymous

  • 11 Answers
  • Posted on May 16, 2009

SOURCE: 2005 Toyota Corrolla Reset Maint Req'd light

make sure your odometer is not on trip, shut your car off, hold down the trip reset button on your gauges, and turn the key to the on position, not start. hold it till the little dashes stop blinking where the mileage usually is, and thats it

Anonymous

  • 288 Answers
  • Posted on Feb 23, 2010

SOURCE: where is the fuse panel on a 1991 toyota corrolla

Inside compartment, in front of driver door. Under hood, behind battery.

Anonymous

  • 173 Answers
  • Posted on Mar 10, 2010

SOURCE: how do i open the hood of my 1998 toyota corrolla

get under the front of the car, use a 10 mm socket with extention and unattach the latch assembly, you may have to loosen up the bumper to give yourself some more room, but you cant take it off completely, because there are 2 bolts right by the latch holding the bumper on, hope this helps and good luck

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

What year and model ignition switches fit 1987 toyota pickup

A seat from a 1987 Toyota will fit in a 1987 Toyota pickup--------------------------------------------------------------------------------------
maxidas ds708
1helpful
1answer

Is there a vacume line to the Transmission on an 02' Toyota Corlla? If so where is it located on the Transmission and on the Engine?

have you replace your trans, or any of its components? you need to reset the memory, disconect negative cable for 5 minutes, reconect warm up engine dont drive it until fully warm up, take it for a test drive and do a couple star -stop at very ligth throtle until normal shifting is confirm, if this doesnot help there was a recall on ecu for this year corolla but you need to verify it at your local dealer, have them run your vin, good luck
0helpful
2answers

An engine from a 1998 would fit into a 1990 toyota 4 runner

yes but itd be easier to find a motor from the same year span a 1998 has different electronics, mounts and size specs but to answer the question yes it would fit with little trouble if any
0helpful
1answer

Need to change head of engine on a 1994 toyota corrolla van. were would i find out about setting the torque wrench or even more info on changing the head

you should be able to go to your local auto store and get a repair manuel for your year and model car. It will tell how to repair almost everything on your car.
1helpful
1answer

How to remove inner door panel 2000 toyota corrolla

Remove the the arm rest pad. It should pop off, check if there is a phillips screw. The power window bezel will pop out as well. Lifer up and remove connector. The inner door handle, remove the screw. Then the door trim pulls off, there is about 7 plastic clips that hold the perimeter of the trim. If you have a flat head screw driver it can help. Pop off all clips and lift in an upwards direction.

1helpful
1answer

I NEED TO SET THE TIMMING ON A1190 16V CORROLLA. I NEED TO KNOW HOW TO ADJUST THE TIMING,. THE ENGINE WAS REMOVED FOR AN OVERHAUL.

Sorry for the delay.
I am personally going back to answer your unanswered question.
I do not know if you still need the answer, but I am going to answer it in case you still do.

Click on the following direct Link. It has the Timing Belt Diagrams that you will need.
Again my apologies...
Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

http://www.2carpros.com/car_repair_information/year/1990/make/toyota/model/corolla/1990_toyota_corolla_timing_belt_diagram_marks.htm
2helpful
3answers

How should i readjust toyota corolla AE 110 tire pressure sensor?

Hi,
Sorry but you can`t, you need specialist diagnostic equipment ,best off taking to a dealer as the sensor is probably faulty
0helpful
1answer

Removing rear passanger door panel on 1993 toyota camary wagon

mmmm from what i can recall 2 screws in arm rest (two small holes underneath arm rest hides the screws)take these out also one in door handle trim behind handle, And the window winder if you look close in the gap between window winder and door trim you should be able to see a curbed metal pin this holds winder in place so to remove it get a knife ( thin blade will fit in between winder and trim) and push on the end bit of the metal pin and it should spring off and then door handle can be removed. After this run your hands around door trim gently pulling around all edges ect this will pull door trim away from supports
0helpful
1answer

Control engine corrolla 1998

Prizms and Corollas are the same car, basically. If it will plug in and run the engine OK, I say go for it.
Not finding what you are looking for?

40 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...