This is an almost impossible task. How do they do this at the dealerships?
SOURCE: tail light works but no brake light on2003 Dodge Ram 1500
if it has a trailer package look at the splitter when you take off the tail light cover might be that plug.
SOURCE: tail lights and brake lights not working with headlights on
We had the same problem with ours, that is a Saturn recall items. Check with your Saturn dealer to see if it is still in effect. It use to make our headlight switch get hot. I think it was a poor ground in the taillight housing, I use to wiggle the bulb plug-ins and that helped for a while, but after the recall was fixed it never did it again.
SOURCE: 94 toyota previa brake lights not illuminating
CHECK THE BRAKE LIGHT SWITCH UNDER THE BRAKE PEDAL
SOURCE: bulbs keep burning out
When you replace headlights in today's cars, DO NOT TOUCH THE GLASS OF THE BULB!. Handle the bulb only with the packing material the bulb ships in, or with a clean dry cloth.The oils in your skin will cause premature failure of the bulb.
Also, check the sockets (car side) carefully to make sure they are not burned.
SOURCE: how to access brake tail light to change
Tail light replacement is not as hard as it seems.
Tools needed:flat head screwdriver and a deep 5/32 socket(a pair of pliers will work).
Step 1: open trunk and pull back truck liner at tail light.There is a small button clip on liner.Use screwdriver to pop up the center of button clip,pull clip out of hole.
Step 2:You will see a black wire attached to the body of car with 2 white clips.Use screwdriver to pop clips off of studs.
Step 3:Remove the nuts from the studs and pull tail light assembly straight back away from car.The outer side of the light just snaps in and out of place.
Step 4:Turn light socket counter clockwise 1/3 turn and pull out.
Step 5:Pull bad bulb straight out and replace.Reverse steps to reassemble.
135 views
Usually answered in minutes!
×