How do I remove rear door panel of my 2007 Kia Rondo ?

SOURCE: 2007 Kia rondo interior lights stay on when headlights turned on

I had the same problem for months. Finally took it to the dealer. The first time, they diagnosed is as a short in the rear interior bulb, and put in a new bulb. Got it home and still had the same problem.

The second time in, they figured things out. On the dash to the left of the steering wheel is a knob that controls the brightness of the dash lights. But, if this knob is all the way on, it turns on the interior lights and keeps them on. Just had to turn this knob down, and the problem was solved!

SOURCE: remove door panel

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

SOURCE: change front rotors kia rondo 2007

Remove the tire, remove the brake calipers, 2 bolts on back side of rotor, remove the carter pin that retains the bolt position if equiped, remove the center nut. When you pull the rotor off watch for a set of bearings to drop out. To install the new rotor reverse the process.

SOURCE: engine light came on kia 2007 rondo

you need to have the code read to see what it is most auto parts store can do that for free that will help use tell you what it is

SOURCE: were is the fuel filter

IT IS INSIDE THE FUEL TANK . IT IS MADE INSIDE THE FUEL PUMP IT IS SERVIECABLE AND RECOMMENDED EVERY 30K . THERE IS A ACCESS TO THE TANK UNDER THE SEAT THERE IS A FEW SCREWS THAT HOLD IT A COVER DOWN REMOVE THIS AND YOU CAN ACCESS .
REOMOVE FUEL PUMP AND TAKE APART THE ACTUAL PUMP SEATS INSIDE THE FILTER .IF YOU TRY TO DO IT YOURSELT BE SURE NOT TO FORGET ANY O RINGS THEY TEND TO STAY IN THE OLD FILTER WHEN REPLACING AND IF YOU DONT SWAP OVER THE VEHICLE WILL NOT START