How can I remove the front disk or rotors in a toyota hihglander
Here's a link to remove the caliber. Repair Guides Front Disc Brakes Brake Caliper AutoZone com Here's another link to remove the rotor. Repair Guides Front Disc Brakes Brake Disc rotor AutoZone com
SOURCE: 1993 totoya camry v6- Changing the rotors
LOL!! Ya they are a pain in the a$$ if it's the year car I am thinking of. Are there 3 "threaded screw holes" near the wheel stud holes? If there is you need a special tool called a slide hammer to get the rotors off. You can get one of these on loan from Autozone for example. And may the force be with you.
If there is not, then you should jump up and down and be glad. Get some rust penetrant and a big hammer, like a 2 or 3 pound hammer. Put all lug nuts on all of the wheel studs (not tight just on a few turns with your fingers) to protect the threads when you are wacking at the rotor with the hammer. This will also keep the rotor from falling on you (they are pretty heavy). Spray the rust pentrant through the wheel stud holes and around the middle where the rotor meets the wheel hub and let it soak for about 5 minutes. Now firmly start wacking the rotor being careful not to hit the actual flat surface of the rotor but the very edge as well as the middle near the wheel studs.
A little cursing at it will improve your chances while you are hitting it. Been there, done that, got the T-Shirt!!
Good Luck!!
SOURCE: front brake rotors 1995 toyota 4runner
If you have 6 bolts going around the center (manual lock in/lock out) hub, you are going to be there a while. The center hub needs to come off, and ALL of the internal wheel bearings need to come out. The whole locking hub must be removed in order get the rotor off. This is NOT an easy job, and you need a special tool to loosen/tightem the wheel bearings. Figure 2 hrs per side if you have all of the proper tools & skill level.
SOURCE: How do I replace the front rotors on my 1993 Toyota Land Cruiser?
have to pull the whole spindle off to get the rotor off..they come off from the back side...real aggravating
SOURCE: how do i replace rotors on a 4runner
remove the 2 bolts holding the front caliper on then just remove the rotor
SOURCE: 2005 rotor removal toyota
Yes.
And make sure you pay special attention to the proper torque when you put it back on as well as take care when you remove this since the bearing are apt to fall out.
Hi, take a look at this site: hope its good enough :)
http://www.scosche-cars.com/encyclopedia/ta891.pdf?userID=374e630d46e5d9fc5814b7baca687048&vehicle_id=TA0342
Glor
459 views
Usually answered in minutes!
×