Where is the fuse located on a mazda 2000 626 lx for the engine light.

The 2003 Mazda Protege LX does not have an inline fuel filter. Instead, it has a "strainer" or a "screen" that looks like a nylon mesh "sock". This strainer is connected to the fuel pump, which is located in the gas tank. The fuel filter is always found between the fuel tank and the engine, and for most vehicles, it is located inside the top of the fuel tank, right where it connects with the fuel line .

Mazda B4000 high mount light fuse location


User
1998 mazda b4000 high mount light doesn't work. where is fuse located? not shown on manual.

ChatGPT
The high mount brake light fuse on a 1998 Mazda B4000 may not be shown in the owner's manual because it is often a shared circuit with other lights and accessories.

That being said, the fuse for the high mount brake light is typically located in the engine compartment fuse box or under the dashboard fuse box. Check your owner's manual for the exact location of the fuse box in your vehicle.

Once you locate the fuse box, look for a fuse labeled "STOP" or "CHMSL" (Center High Mount Stop Lamp) or "BRAKE" that is related to the high mount brake light. Use a fuse puller or needle-nose pliers to remove the fuse and check if it has blown.

If the fuse is blown, replace it with a new fuse of the same amperage rating. If the new fuse also blows, there may be an underlying issue with the wiring or the high mount brakelight assembly itself that will require further investigation by a qualified mechanic.

If it is running, you don't need it.

Fuse Box Diagram Mazda CX-7 (2006-2012) - Fuse-Box.info

https://fuse-box.info > mazda > mazda-cx-7-2006-2012...

2010 - The fuse box is located on the left of the steering wheel behind the cover. The location of the fuses in the passenger compartment: Mazda CX-7 (2006 ...

P0401 Exhaust Gas Recirculation Flow Insufficient Detected

There is an alternate problem with the wiring in the cigarette lighter where the wire melts and breaks. If you pull out the cigarette lighter assembly you will see a place where one wire splits into two. Find the damage point and replace the wire with a thicker one.

02 sensor or a list of other things. Have a tech hook it up to a testing unit and see what code it gives off.

most of the time problems with lights are directly linked to fuses. locate your fuses and check for burned out ones.

U most likely need a new backup light switch, it is screwed into the trans case, here is a picture.

Pick up a code reader and that will let you know a little more n what is going on.

there are only two. one in and one out.