- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Call your local dealer Monday morning with your vin number in hand and ask for the parts dept., they'll tell you or tell you who to call. I had to go this route with my Mustang Cobra.
The orifice tube is located in the evaporator inlet pipe at the liquid line connection. The evaporator is located in the right rear side of the engine compartment. .
Well your clunking noise is most likely the u-joints the leaking pan is the ****** pan what you would have to do is get a ****** kit and change the pan gasket ****** filter and fluid or take to a shop and have a ****** service done.
After an oil change, or when "CHANGE OIL"
appears on the Trip Monitor, with the ignition on and engine off, press the
"ENG MET" button (located on trip monitor) once. Press the "ENG MET" button
again within 5 seconds. Within 5 seconds, press and hold the "RANGE" button
(1990-1994) or "GAUGES" button (1995). The light will flash. When it stops
flashing and goes out, the system is reset.
Hope this helps and just keep in mind that your feedback is important
and I'll appreciate your time and consideration if you leave some
testimonial comment about this answer. Thank you for using FixYa.
The serial number (for an F2 engine) is positioned on a plate below Spark Plug #1. It starts with "F2" in large letters, followed by a 6 digit number in smaller characters.
×